Search: toshiba
Results: 5617
Make Model Symptom Problem Solution By
TOSHIBA U14 TV 1490 , 2090
Hang up Q430 getting very hot d448 open
TOSHIBA U14
Takes time to call C887 100mf 16v changed
TOSHIBA TV-2998
No horiz/vert sync C214 1mf changed
TOSHIBA MS6531
No Sound Q802
SEMP TOSHIBA TV 485HM
Burning strg 5653 R876 the 680r
TOSHIBA TV2086
Contrast does not work R218 and r327 changed
TOSHIBA TC-14A10
Image in half and folded at the bottom 1uf c425
TOSHIBA 285D8W-D
Takes a long time to start (only stand by read on) voltages at the output, absent, analyze the diagram there are 2 transformers at the voltage output Analyze and change c842=330mf/25v
TOSHIBA 28N33D CH.11AK37-11
There is sound, there is no deflection, there is no horizontal waveform in the drive. Replacement of r639=10k , c653=47nf , d407=1n4148 and r246=2 . 2k
TOSHIBA 28N33D CH. 11AK37
No voltages at the power supply output. Replacement of the power supply transformer.
TOSHIBA 2512DN
Low amp. vert. and folded at the bottom. with trembling. after 1 min. black screen C317 2,2mf 50v longe do ic vert. escondido debaixo do mod. ew
TOSHIBA 256T9W
No v and h synchronization due to antenna signal in av ok Replace cond elect. inside the tuner
TOSHIBA 28N14G CHASSIS CUC2130M
There was no image, the 34015 stv2248 ci was getting too hot, I detected that the 8v ci supply voltage was high, with 12 volts D5405 zener de 6,8 volts
TOSHIBA 2812DN
Closed vertical with about a span of image, stable cases with a clear defect also in the east-west R424 in the east-west module (ds-1107), also remove all electrolytics and wash the module as they almost always show signs (and smell) of leakage.
TOSHIBA 2100RNT
Didn't do standby Bux84 transistor (q804)
TOSHIBA 2100RNT
Didn't care Tsl hr7669 + transístor q404 (on4409) pelo 2sd1556
TOSHIBA 2563DN
That's it Enrichment
TOSHIBA 28N14G
That's it R53072 , r50048, stv9306
TOSHIBA 28N33D
In cold weather it takes time to focus the image Replaced TRC support (it was oxidized but didn't solve the problem). clean the focusing pin very well and put silicone on the plastic base of the trc barrel.
TOSHIBA 2812DN
Vertical only opens completely after around 15 minutes, during which time the e/w is also incorrect C374 ce/220mf for module e/w