Toshiba Repair Tips
Search: toshiba
Results: 5617
Results: 5617
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
TOSHIBA |
TV1451
|
Very low low sound | C613 220x25 low capacitance at 90 nm | Replace it and go for the hug | orlando lott |
SEMP TOSHIBA |
1451NAV U18
|
Very low sound, you could barely hear it just put your ear to the speaker | Capacitor c 613 220uf 25v | Capacitor c 613 220μF 25v | OP Eletrônica |
TOSHIBA |
TV-2015N
U18 |
Low sound | C635 and c613 of 220ufx25v exhausted | Replace them with new ones | EK Eletrônica |
TOSHIBA |
TV2934
|
TV turns on and off, when the screen increases, a line appears in the middle of the screen as if it were vertical | D306 open | Replace the d306 | Emerson |
TOSHIBA |
40RV800
|
TV doesn't turn on. The green LED lights up, power supply 24 ok | Q 100 short, change it and smile, you are on the globe again | rubens p afonso | |
SEMP TOSHIBA |
TV2959
LEM10 / FS8 |
No power supply | R874 (220k) | Cleber | |
SEMP TOSHIBA |
U19
|
Vertical with line in the middle of the screen and dashes at the top | Capacitor near the micro was broken, at first I thought the problem was in the power stage, I replaced all the components, capacitors, resistors, ci tda 9302 but it wasn't, this TV even opened the screen completely but after some time of operation it started to close the frame | Capacitor c301 on the capacimeter was normal, but it was altered, failing internally, replace without measuring | rubertan eletr silva joao monlevade |
SEMP TOSHIBA |
TV2922(JFS)
LEM10/FS8 |
TV doesn't turn on, LED doesn't light up and tsound is no secondary voltage | Capacitor c880 10nf(smd) | Replace and run for the hug | ELETRONICA MARANATA |
SEMP TOSHIBA |
DL3271(B)W
|
Burned by lightning, inoperative | Icp1 tea1733smd | Eletrônica Cecé, Brumadinho mg | |
TOSHIBA |
TV2999KMS
LEM7 |
No contrast | A line of lines | Replace resistance and give glory to god | Abençoado |
SEMP TOSHIBA |
LE3256 BW
|
Turn on the LEDs without image | Change without measuring, capacitor cd25 on the display board | novaeletronicauberlandia | |
TOSHIBA |
DL-4845
|
Washed screen, with backlight, with sound | After testing, the LEDs lit up, but no image was generated. TCOM board test | I tested the tcom fuse, ok, but tsound was no avdd voltage, I tested the line of capacitorsc14,15,16 and 17, which are the same value. cd14 was shorted.replace voltage returned to normal.image generated perfectly. | ELETRÔNICA ESTUDIER-OLIBIO |
TOSHIBA |
TV2923
LEM10/FS8 |
Acting protection- integrated power supply- 10ufx50v acting protection | C884 capacitor 330uf x 160v faz queimar d883 | Replace electrolytic integrated foot 10x50v - replace the secondary 330μF 160v and quick cut diode: d883 - and go for a hug | SFTV-SILVINHO |
TOSHIBA |
DL4844
|
On always appears and turns off (1 LED burned out on the bus (I put 1 6V)) | I changed the LED and the defect persisted..then I replaced the r766..it continued the same, defect persisted..this TV has the LEDs turning on even without the display..(summary(..I reviewed everything I did..in the soldering r766...broke the track...from pin 10 n701 that goes to r766)) | After soldering r766....check the track as it is a micro track...it breaks easily when changing the r. | Alextecnico |
TOSHIBA |
TV2999KMS
LEM7 |
TV turns on and then turns off, image appears and then turns off | Cold sole in kb20 on the vertical side | I resoldered the same and the TV looked great | Antonio Carlos (Eletrônica Renascer) |
TOSHIBA |
TV2177
|
Does not tune channels | D401 dz10v | carlinhos100 | |
SEMP TOSHIBA |
LC4046FDA
|
Turns on and the screen goes dark with no sound as if it wasn't turned on | Bad main board | Replace main board | Gabriel |
SEMP TOSHIBA |
DL3975I(A)
|
The screen doesn't light up | DP15 smd diode near the LED power connector shorted | I placed 02 sr5100 diodes in parallel in the dp15 position | Eletronica Cecé- Brumadinho MG |
TOSHIBA |
TV 2916NMS
LEM10 |
Low or no sound | C636 e c637 | Replace | Mauro Mascarenha Tel : (88) 981422821 Parazinho - Ce |
TOSHIBA |
2999
LEM6 |
No video on the av and if you deactivated the blue screen it would turn white | The defect was the micro | Replace microprocessor, if your micro is 8859crng5jf2 you can put the 8859crn5jf2 | Bardock Eletrônoca |