Repair Tips
Search:
Results: 87717
Results: 87717
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV25XBR
|
Missing part # | We need the bezel assy for kv-25xbr in black which usesa slightly darker bezel than the one for beige or plum.is there a different part? -hq comments: kv-25xbr is marketed in only one bezel gray shade version.but in practice it may vary within the produ | ||
SONY |
D5
|
Disc overrun | In service mode, the disc motor turns very fast. | ||
SONY |
FD40A
|
Pin cushion distortion, replaced q856 | Set displayed severe pincushion distortion. inspection ofthis transistor revealed e to b region was open. | ||
SONY |
CCDV8
|
Snowy playback picture | Snow on picture, missing one rf envelope (defective drum). | ||
SONY |
CCDV8
|
No video due to broken 24 pin connector | Inoperative loss of video on vhf out. video out ok. | ||
SONY |
CFS300
|
No sound from tape player | Am/fm works fine, but no sound from cassette player. | ||
SONY |
SL2001
|
Unit shuts down after a few seconds | Unit shuts down a few seconds after play button is depressed. | ||
SONY |
SLHF900
|
Intermittent audio pop | Dealer has reported that four units in stock have the follow-ing problems: during pause/edit, unit give an audio pop intermittently. -hq comments: if a pop noise is heard in hi-fi playback, add a 4.7ufelectrolytic capacitor across r510 on the af-9 boar | ||
SONY |
SL2410
|
New guide pins are hitting cassette lid while loading | New guide pins are hitting cassette lid while loading result-ing in noisy operation. -hq comments: you must use the part number in the s/m for the guide #1and #2. the pin kit a-6759-107-a cannot be used in this model. part # needed: x-3669-429-0 | ||
SONY |
TCFX520R
|
No ff/rew | Unit would not go into ff or rew. brakes remained on. playand music scan operated normally. | ||
SONY |
TCFX707R
|
Unit dead - no operation | Found r506 blown, replaced same. transport worked, but nodisplay and no playback audio. found ps302 open, replaced same. all ok.ran several hours. noticed pb level started to drop intermittently.later, the display showed low and the audio had dropped | ||
SONY |
SL5200
|
Distorted audio | Unit works properly in 3 shops. when in customer,with video from vcr, beta hi-fi will drop out. happens when recordinglevel exceeds 6 on meter in manual or anytime in audio record level.when recording fm audio on tv audio, no problem. dynamic range? | ||
SONY |
STRVX550
|
P/n for black cabinet parts | We need the part number for the black upper case, as well asnumbers for the other black style cabinet parts. -hq comments: part number is 4-886-109-31. the part is the same ascdp-610es | ||
SONY |
BMC550
|
Drum ass'y | The s/m of bmc-500 unit gives the same part number as well asfor the bmc-110. but they are different, cannot be mounted properly onthe a-6050-209-a. the opening is much smaller and will not go over thescrew holding the track which the threading ring ri | ||
SONY |
WM16
|
Stop button stuck down | Stop button stuck down. | ||
SONY |
BMC110
|
Picture break up when recording outdoors | When recording outdoors, the picture is intermittent with theedges of objects breaking up. in all cases kodak l750 tape was beingused. in one case tdk l750 tape was used. tdk makes kodak tape. -hq comments: it was determined that the problem occurred | ||
SONY |
KV1952RX
|
No part number for cp003, 1-417-087-00 | No part number in the service manual for cp003 located on the mu board. | ||
SONY |
KV2680R
|
No picture and no sound, c-140 on "a" board | Problem was no picture and no sound. asc hooked up thiskv-2680r p3 chassis to his rca test jig model 10j106a using telematicadaptor 10j733 (color tv s/b #212). | ||
SONY |
XM120
|
Intermittently stays in protection mode | Unit would intermittently go into protection mode when turnedon, or while playing. also when acc power was removed, unit would go intoprotection mode and would not shut off. unit continued to draw current. | ||
SONY |
KV1354R
|
No programming, replaced q-024 | Unit would not hold memory. when you set tunning switch on vcwould go to max. and green tuning bar was all the way across. checkingaround memory chip ic-002/pin 2 had no -25v. found q024 open.also found that q-024 on some sets replaced with a 680Ω |