Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CCE |
HPS 14R
|
Vertical glossy stripe | D 411 burst replacing the same one heated burning reason c410 open, without capacitance. | ||
CCE |
2002
|
Without video with the screen divided into three colors | Be careful with these cce, you think the defect is in one block and it is in another. In this case it was solved just by changing the vertical ci, ok. | ||
CCE |
HPS 1403
|
Image with a one centimeter strip on the side. | Changing the electrolytic c825 horizontally. | ||
CCE |
HPS 2981C
|
Jagged on screen closing horizontally disarms. | Capacitor replacement at point jc96 470k/63v | ||
CCE |
HPS 2070
|
Did not tune to low channels | 33k resistor changed to 34k on the micro pin. | ||
CCE |
HPS 2980
|
LED turns on TV activating power LED turns off activates relay TV does not turn on | Secondary power supply +b 12vdc I turned off the TV power supply it continues +b 12vdc q 801 heats up even without load, I changed all the electrolas. the ic tda 4601 and nothing I removed the t804 transformer I tested it in my transformer test and it was filthy looking under the transformer you could see a dark varnish that melted after replacing this transformer the TV became zero bullets. | ||
CCE |
HPS 2007
|
Does not oscillate without horizontal pulse | I tested everything, after replacing the uoc tda 9570 which cost a mere 80.00 reais it worked fine. | ||
CCE |
HPS 2981
|
Zero power supply | Vertical la7838, horizontal bu 2520 and cap c418 1kpf/1kv shorted. | ||
CCE |
HPS1470T
|
Vertical shadow over the image when decreasing brightness, with phase slightly shifted | R401 or r427 changed (4k7), I can't say which because I took both at the same time and one was changed and they have the same values | ||
CCE |
HPS1470T
|
Vertical shadow over the image when decreasing brightness, with phase slightly shifted | R401 or r427 changed (4k7), I can't say which because I took both at the same time and one was changed and they have the same values | ||
CCE |
HPS2004
|
Image without definition (totally out of focus) with vertical green, blue and red bars like a generator. | Ci vertical (tda9309) | ||
CCE |
HPS2004D
|
No contrast and lack of width | C825 (47uf/160v) | ||
CCE |
HPS2004D
|
Does not light filament, with low flay output voltages. | C829 (33uf/160v) | ||
CCE |
SS-5880
|
No Sound | Ic901 (ta7417ap) e q902 (bc547) | ||
CCE |
HPS-2070
|
Horizontal line | Ci1301 (la7837) | ||
CCE |
HPS-2070
|
Inoperative, fuse open | D807, ic705 e ic801 | ||
CCE |
HPS-1465
|
Without image and/ sound | C413 (330 pf) | ||
CCE |
HPS-1430 R
|
Poor vertical deflection | C356 (1000 µf 35 v) e c357 (100 µf 35 v) | ||
CCE |
HPS1470T
|
Vertical shadow over the image when decreasing brightness, with phase slightly shifted | R401 or r427 changed (4k7), I can't say which because I took both at the same time and one was changed and they have the same values | ||
CCE |
HPS2004
|
Image without definition (totally out of focus) with vertical green, blue and red bars like a generator. | Ci vertical (tda9309) |