Cce Repair Tips

Search: cce
Results: 4816

Make	Model	Symptom	Problem
CCE	HPS1470/2070	Reduced frame on 4 sides	Cristal x501.
CCE	HPS1405 HPS2005	Burns the ic901 (tda6107)	Check the d902/903/904.
CCE	HPS1403/2003/2006/2706	TV doesn't turn on. stand-by LED blinks	C826 on the run.
CCE	HPS1402	Transistor q402 tsh burns out without apparent cause.	Make the recommended change r411 from 2k2 to 4k7 3w.
CCE	HPS2090C	Voltage of 180v very high, it reads 256v and therefore the capacitor c555 bursts	Change the c415 (33mf/160v), if that's not the solution, change the fly.
CCE	HPS2081	TV doesn't turn on. the LED stays on and does not oscillate horizontally. o +b ok. when touching the finger on the q802 (stand-by power supply) it starts	Diodo zener d823
CCE	HPS14R	Closed horizontal, i.e. vertical line	C410 open
CCE	HPS 2080	Inoperative or intermittent	1n4002 which on the board's printed circuit is in place of r417
CCE	HPS 2997	Symptom similar to exhausted kinescope	Check r423,r424 and c421
SOM CCE	MD-K222D	Distorted audio and volume does not work	Q505 bc337 open
CCE	HPS-2004	Vertical closed	Replace c 405 (smd) 2kpf/50v fica no pino 42 do ic 501 (tda 8841)
CCE	HPS-2004	Closed frame on the sides and bottom	Replace q 501 847 fica no pino 35 do ic 501 (tda8841)
CCE	HPS-2981C	1st- vertical closed 2nd- no video	1st - ci601 7809 had a voltage of around 4 volts. 2nd - diodes d203, d204, d205 (1n4148) and the transistor q201 bc327 shorted
CCE	HPS-2003	Frame varying the width as the image varies	Abl control resistor 470r 1w, on the abl control pin on the fly --------------------------------
CCE	HPS 1470	No audio	Please 403
CCE	HPS 2080D	No audio	C722 10n shorted.
CCE	HPS 2981	Image only clear figures	R 423 1k open and r 435 4k7 changed to 20k (smd)
CCE	HPS 2002D	Normal power supply device does not turn on	Q802 bc 337 no gain.
CCE	HPS 1480	Vertical closed r312 2.2r changed.
CCE	HPS 1480	Does not tune channels	R704 180k changed