Cce Repair Tips

Search: cce
Results: 4824

Make	Model	Symptom	Problem
CCE	HPS 14	Colorless television and no sound from speaker	Cause of the defect q-801, replace it with a new one.
CCE	FLY BACK MARCA CCE	Model that has 5 turns of wire around the ferrite core of the fly back	Inverting the position causes a strong black bar on one side of the image, or excess width; Be careful because the rush means that these details go unnoticed and then you would be looking for a defect where it no longer exists.
CCE	DICAS DE CONSERTO - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Add color or out of phase	Change the value of resistor r203 from 100r to 330r; - change the value of capacitor c401 from 12pf to 15pf; - check “sand-castle” pulse on pin 5 of ic502; - if the tda8361 is version (4x), replace it with (3y), also changing the resistor r501 according to the IC version.
CCE	DICAS DE CONSERTO - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Dark stripe on the side, poor video and chroma	Check r427 (4k7 changed), r403 to 405, d401, c401, ic402; - reverse connection of the wire wound on the fly-back ferrite (± 4 turns).
CCE	DICAS DE CONSERTO - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Vertical closed	Verificar sw201, c301 a c308, r301, r312/313, d301/302, ic301.
CCE	DICAS DE CONSERTO - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Reduced frame on four sides	Check r501 according to the version of ic501 tda8361, being: 47k for version (3y) or 8k2 for version (4x and 5); - check crystal x501.
CCE	DICAS DE CONSERTO - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	TV turns off by itself or after turning it off, via the keyboard or c.r., it won't turn on again	By turning it off and on again via the AC cable, the TV starts working again. This problem occurs in locations with a low AC network. - replace the 2k7 - 10w resistor r806 with 1k5 - 10 or 15w; Attention:- in some TVs there are 3 8k2 - 3w resistors in place of the 2k7 - 10w resistor. Solder the resistor well away from the PCI. - replace transistor q704.
CCE	CCE 2002	Without video with the screen divided into three colors	Be careful with these cce, you think the defect is in one block and it is in another. In this case, it was solved just by changing the vertical ci, ok?
CCE	ALTERAçõES - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Improve self-programming	Change the value of resistor r204 from 4k7 to 6k8 ½ w - metal film
CCE	ALTERAçõES - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Improve character intensity	Change the value of the resistors: r744 from 4k7 to 3k3 ½ w - metal film r745 from 4k7 to 6k8 ½ w - metal film r746 from 4k7 to 5k6 ½ w - metal film
CCE	ALTERAçõES - HPS 1470 / 2070 - SéRIES P / Q / R / S / T / U / V	Optimize reset circuit of ic 701 (micro)	Does not tune channels - change the value of capacitor c718 from 1mf/100v to 2.2mf/100v; - change the value of resistor r740 from 220r to 150r ½ w - metal film.
CCE	3EM1 SS-5880	No Sound	Ic901 (ta7417ap) e q902 (bc547)
CCE	HPS 2990	Poor tuning, goes out of tune	Cold welds next to the selector and the printed wiring board
CCE	HPS 2981	Works normally: after 3 minutes, it emits a high-pitched noise, damaging the transistor q 801 (bc 4430)	Capacitor c 890 (22u f x 25v) with loss of capacitance or high esr
CCE	HPS 2781	Remains in stand-by, even if you press any key	Faulty vertical scan cl
CCE	HPS 2781	Inoperative, remains in standby, 5v line "zeroed"	Tuner (varicap) short
CCE	HPS 2780	Burning horizontal output transistor and 0.47 resistor	Damping capacitor with loss of capacitance or open
CCE	HPS 2780	Dead	Transistor q 402 (bu 2520) short and resistor r 410 (0.47r) open
CCE	HPS 2181	Dark band on the left of the screen when receiving weak signals	Remove from the circuit r714 (470k) and the capacitor c 710 (150 pf)
CCE	HPS 2095	Retrace lines at the top of the screen	Capacitor c 302 (47 f x 50v) with loss of capacitance or high esr