Cce Repair Tips
Search: cce
Results: 4815
Results: 4815
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
TV2118USP/AV
SL23-1 |
The TV turns off after a few minutes of being on | Q802/q804 transistors | Replace for bd 135 | MARCELO FLACH (ELETRONICA CENTRAL) |
| CCE |
TVD2901
|
TV doesn't turn on, stays on stand-by | Tsound is no oscillation...cause it was a horizontal output, measure the tension in the collector tsound is tension, measuring it seems to be in place...but you have to remove it from the place to measure, because it is with the driver...I measured it in short... | Replace q402 - bu-2520dx | |
| CCE |
HPS-1402E
|
In a/v normal image, but in rf it gets black screen | Check coil l201, the video signal comes in but does not come out. | If it's open, replace it and it works. | lelobq |
| CCE |
HPS1490J
|
Dark screen no video no sound with retrace lines. menu information and normal characters, normal grid, high and video voltages | Transistor q740= bc547b | eletronicard | |
| CCE |
HPS144
|
TV tried to work but it didn't turn on, it lit the filament three times and turned off | Replace transistor q802 bc547 (change without measuring) | Deusomar | |
| CCE |
HPS2171FS
|
It takes time to turn on when turning on blurred image | Frey back ruim | HAVAI | |
| CCE |
2918USP/AV
|
Dark stripe on the left side | Friends, don't forget that r401 abreto also causes the same defect as c 402 - good luck | haecio | |
| CCE |
HPS-2991FS
|
Closed horizontal | C409 ruim | Replace c409, resolved. | ROBERTO |
| CCE |
TV-2118
|
TV breaking and cutting out after pressing the power key. Note: changing the screen the screen appears as if it were a video defect. | C 417 of 331pf shorted, it is connected to the horizontal terminal of the deflector. | Replace of c 417 of 331pf/2kv | geroge pontes |
| TV CCE |
HPS 2997 FS
|
This TV is working, the filament of the tube heats up the micro, the horizontal or the vertical, everything is working but the image is not coming. | It activates the fencing when I turn off the 250v current from the RGB, which erodes the flaibk potentiometer, but it ends up with a return line. | The defect was just the 120k c901 capacitor, replacing it with another, the TV was resolved. | BF.COLATINO |
| TV CCE |
HPS 2073
|
This TV turns on normally, but with a blue screen and retraces and it doesn't turn off either with the control or the power on the panel. | With the blue pin on the micro stuck, the other voltages r and g are set to zero. When I release the pin they appear. | I resolved the defect, replaced the micro and the TV was great! | BF.COLATINO |
| CCE |
HPS1407
HPS1407 |
TV didn't even tune to one channel | Q401 transistor | ozenildo | |
| CCE |
HPS 2981
|
Running away from tune | Change the capacitors of coils t103 and t102 | Values for the capacitors in the coils. t 102 put 33pf t103 16pf | itan (cabeça) |
| CCE |
HPS-2070-2080-2081
|
TV doesn't turn on b+ ok with 103v when turning on the stand bay the LED keeps blinking @@@ | Flaybek tat2006 | Help yourself, leave your tip ass.arni | ELETRONICA ARNI-LEOBERTO LEAL-SC |
| CCE |
HPS-2070-2080-2081
|
TV doesn't turn on b+ ok with 103v stand bay LED off @@@ | Q401 = bf422 horizontal | ELETRONICA ARNI-LEOBERTO LEAL-SC | |
| CCE |
HPS2907 FS
|
Power supply with noise ticking, ticking and after turning off the load of the +b 132v power supply varying the voltages of the +b132v. | Short d 808 and or d812 of +b 14.5v | Bruske | |
| CCE |
2070
|
TV has 115v and does not oscillate. | Crystal x701 | barbosa | |
| TV CCE |
HPS2071
|
This TV has a black band on the left side of the image, I entered its service mode to try to adjust it but no bit changes this adjustment | Solved, the problem was the c405 with 2n2 smd is on the side of the chip, and then when I turned it on the sound only hissed through the tuner and in AV it had normal sound so it was the c601 with 1n2 smd on the side of the chip. | bf.colatino | |
| TV CCE |
HPS 2001 G
|
Looking at the power supply, I measured the voltage of the +b and tsound was no voltage on it and I also replaced the c842 and c843 without success. | The defect was in c 411 on the horizontal line, it was open, it was just replaced and the TV was fine. | bf.colatino | |
| TV CCE |
HPS 2198
|
This TV is as if the volume key was pressed, I fixed it, I checked with the test on the x1 scale if the key was acting up, I followed the path to the computer and found nothing. | I removed the volume key - and replaced it with a new one, it was fine for a few days and then returned with the same defect | Hi, I replaced all the touch keys and it was fine. | bf.colatino |