Cineral Repair Tips
Search: cineral
Results: 427
Results: 427
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CINERAL |
TC-PL2900
|
There is no image, but there is sound | Dark image | Changing the open coil l231, line to the base of the v212 and input pin 42 n201 | lou |
CINERAL |
21P-CIN0405
|
After a few minutes, horizontal lines appear as if it were a vertical defect | Q844 bc847smd open intermittent | Replace without measuring | paulo-maceio/al |
CINERAL |
29PCIN 0507
|
R840 120k 1/2w (aberto) | Wilson (Bauru -SP) | ||
CINERAL |
21P CIN-0405
|
With the OSD flickering and normal image | Diodo zener 8v2 (j405), com fuga | This diode is below the PCI, pin 7 of the flaback | HIPERELETRONICA SERVICE (MARCELO MARAIAL) |
CINERAL |
TC2070
|
Turning off by itself after a few minutes | Q103 = bc337 | Danieleletronica | |
CINERAL |
TCPL-2955
|
Vertical opens the date, opens the date. | Exchange without testing d-301 (1n 4007) with leak | Ademar / Videira sc | |
CINERAL |
21PCIN0405
|
Turns on alone with reduced screen does not follow commands | Change c-19 and c-20 10k capacitors (reset) | Ademar / Videira sc | |
CINERAL |
TC 14
|
LED blinks and goes out, power supply stays charged and does not arm | C807 as low capacitance | I put 10/350 | Ádrian Chapadão do Céu-Go |
CINERAL |
VARIOS
|
Turns off intermittently/or whenever | Check the open 240k r420, change the two resistors that supply the +b of the fly back (1r6) remove q16, it is not necessary to put it back and if the r 420 is good, add a 390r resistor with the c409 | Ademar / Videira sc | |
CINERAL |
14PCIN0401/21PCIN0405
|
No horizontal synchronization | Exchange d405 | Ademar / Videira sc | |
CINERAL |
2977
|
Too much width | Change the electrolytic c227 d 10 x 250 volts | Ademar / Videira sc | |
CINERAL |
1470
|
Works and stops | Change q 102/ and q 103 of the power supply | Ademar / Videira sc | |
CINERAL |
TC 2033
|
+b low in secondary | Replace tl 431 ic 102 | Ademar / Videira sc | |
CINERAL |
TC 2022
|
Sem as one of | Replace o ci la7285 | Ademar / Videira sc | |
CINERAL |
TC 2053N
|
Doesn't start | Replace the diodes d825/ d808/ d 809 d810 | Ademar / Videira sc | |
CINERAL |
TC1411
|
Doesn't work | Capacitor eletrolitico (c706-470uf/35v) | ELETRONICA LELO | |
CINERAL |
TCPL2955
|
Turns on normally then expands horizontally and turns off | Power supply ic802 | Replace tda16846 | paial.eletros |
CINERAL |
TCPL-2955
|
Doesn't start | Ci power supply controller - ic801 | Replace ic801 with another | danielpauly |
CINERAL |
TC 1470
|
Vertical closed with horizontal line closed at the bottom of the screen | Transistor q102 open | Replace the q102 (you can put the bc337) | Eletrônica Megatron |
CINERAL |
14 CIN0401
|
I replaced the smd transistor | Changed the q841 | I replaced the smd transistor |