Cineral Repair Tips

Search: cineral
Results: 427

Make	Model	Symptom	Problem	Solution	By
CINERAL	21P CIN-0405	Turn on and off	Q846 ss8550		Eletroclaudio Aguas Belas PE
CINERAL	TC-PL2110	It doesn't start, when plugged in the LED lights up and then goes out and the secondary voltages are normal, except the 3v3 voltage	C 130 of 100uf measuring 110uf and q103 (bc 337) measuring good but replace it	Replace c 130 and q 103 tv ok.	geroge ponttes
CINERAL	TC-PL2910	Sometimes it turns on and sometimes it doesn't.	Cold solder on 5 and 8 volt regulators n505=ka7805 en503=ka7808.	It was just a matter of resolving and celebrating.	Armando de Olímpia
CINERAL	TC2011	With audio without video in av	Qv03 open	Replaced and resolved	BF.COLATINO
CINERAL	21PCIN0405	Does not turn on low power supply	Replace eeprom		klein
CINERAL	29PCIN-0507	TV oscillates, has filament, but still has a dark screen	The screen capacitor was checked, ok, but when measuring the screen voltage it was very low, even adjusting the fly back, it was no use. "causes" bad fly back.	Solution replace fly back and good luck!!!!!	TOPMAR ELETRONICA
CINERAL	14N CIN-0401	Normal power supply, the stadbay LED does not turn off	Change memory Just remove it and the TV already has it to turn on		ELETRONICA ARNI-LEOBERTO LEAL-SC
CINERAL	21PCIN0405	It doesn't turn on and the Stamby stays on	After doing the research, I found the ic 301 tda4864aj short, I replaced it and the TV worked without focus, however I checked the kinescope board and found the kinescope pins were oxidized, cleaned and the focus returned to normal.	I replaced ic 301 tda 4864aj and cleaned the kinescope pins	mjb
CINERAL	TCPL2910P	Time it turns on, time it doesn't turn on and it kept accumulating current in the power supply	High voltage vd524 rgp30j diode had placed a common diode in its place	Replace for a high voltage one works normally ok	Eletroclaudio Aguas Belas PE
CINERAL	TCPL2910P	Doesn't start, just keeps talking, correct	5q1265rf supply regulator defective	Replace	Eletroclaudio Aguas Belas PE
CINERAL	TS2977	Red streak below the center line of the tube.	Voltage on pin 9 of the micro (tda9570) low 2v3 had to be 8v, l501 open		Marcio Santos
CINERAL	TC2070	Blinking led	Fr231 open I changed it and April again the cause was c226 connected to the horizontal output collector	After changing the fr231 and c226, the TV worked perfectly, that's it guys, let's help next time.	This email address is being protected from spambots. You need JavaScript enabled to view it.
CINERAL	TC-1470	Doesn't start	Ic 103 l7805 e q 102 bc 635	Test if you have problems, just replace	Eronaldo
CINERAL	TCPL2910P	Vertical closed	L 301	Switch open	mauri junior
CINERAL	21P CIN-0405	No power supply	D820		DANIEL SOLANEA PB
CINERAL	32LCIN-1010	Doesn't start	Power supply capacitor	Cs3 (2200/16) direct swap	MB ELETRONICA
CINERAL	32L CIN-1010	White vertical stripes, does not obey commands	Cs3 2200/10v aberto	Replace it with an equal one with at least 16v.	ÁdrianChapadãodoCéu
CINERAL	TC- PL2910P	Keeps losing the sound back and forth	C532 electrolytic 470mf 16v	Friend, this solves it.	manin
CINERAL	TC PL 2910P	Keeps losing sound	C 530 electrolytic 470mf 16v		manin
CINERAL	2910	Doesn't start	C404 shorted (vertical)		HP ELETRONICA