Daewoo Repair Tips
Search: daewoo
Results: 145
Results: 145
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| DAEWOO |
T512
|
Poor greyscale tracking . | C504 sc | ||
| DAEWOO |
T200
|
Trips 3 - 4 times then dead | C807 120µ 400v | ||
| DAEWOO |
T200
|
St/by only - relay clicks ok | C410 1nf 2kv in lop stage smoking & faulty | ||
| DAEWOO |
T140
|
Dark pic - non existent until a1 turned up | C542 10n 3kv on crt base int | ||
| DAEWOO |
N/K
|
Rainbow raster - sound ok | Field o/p chip faulty | ||
| DAEWOO |
GB5582TX
|
Pick fades out maybe once a week | Dry joints loptx heater pin | ||
| DAEWOO |
GB2898ST
|
St/by only | C815 1000µ 25v o/c | ||
| DAEWOO |
GB2898ST
|
Sound only - no line drive | R820 feed to 12v & 8v feed should be 2r - was 10r in this case | ||
| DAEWOO |
GB2898ST
|
No picture - sound, heaters, eht were ok. | Decoupling cap c417 4n7 400v leaky | ||
| DAEWOO |
GB2898ST
|
No e/w correction | Q404, next to the e/w o/p tr 2sc3198 leaky | ||
| DAEWOO |
GB2898ST
|
Buzz on sound at low level | Resolder fop chip heatsink | ||
| DAEWOO |
GB2898CTV
|
Arcing in scan coil plug blew components | Field chip tda8351, then bright blue raster - tda6106q b o/p chip on crt base | ||
| DAEWOO |
GB21F1T2
|
Dead - 4a mains fuse blown | C842 4700pf blue bead cap burnt & short | ||
| DAEWOO |
GB20A5
|
No picture sound ok power supply working ok | Ic1301 tda8356 _ d301 5.1 zener | ||
| DAEWOO |
GB14H1T
|
Sync absent | Eeprom - [clock & data lines on video ic were low by approx 1v] | ||
| DAEWOO |
GB14H1T
|
Service mode entering | On hset press blue > yellow > green > red > stby sequencially. when brought out of st/by should be in service mode. use buttons 1 & 4 for slope adjust; 2 & 5 for vert centre; use buttons 3 & 6 for vert amp... | ||
| DAEWOO |
GB14H1N
|
Won't come out of st/by, sw off when playing, osg corrugated - all int | I826 3.3v reg le33cz on front of pcb - available from farnell | ||
| DAEWOO |
GB14H1N
|
Sound absent & snowy pic aft re-assemby | Check pl/skt conns of spk - can be accidentally put in set agc skt | ||
| DAEWOO |
GB14H1N
|
Service mode entering | Press "norm-av-sleep-clear-stby" on r/c | ||
| DAEWOO |
GB14H1N
|
No tuning - supply & clk/data lines ok | Tuner faulty - replaced type dt5-bf18d pt no 48597-19930 |