Daewoo Repair Tips
Search: daewoo
Results: 145
Results: 145
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| DAEWOO |
CMC1424S/1425S
|
No contrast adjustment. | Check of q202, v202, r209, r214, vr202, ic801. | ||
| DAEWOO |
CMC1424S/1425S
|
Vertical line on the screen. | C317 e c421. | ||
| DAEWOO |
CMC1424S/1425S
|
On the screen is colour heel. | Check of dp001, pr001. | ||
| DAEWOO |
CMC1424S/1425S
|
Monitor is not on, a fuse f001 is good. | Check t001, d007, r003, d006, q001, q002, ic001. | ||
| DAEWOO |
CMC1424S/1425S
|
Monitor is not on, a fuse f001 is open. | Check of d001, c001, dp001, rp001, ic001. | ||
| DAEWOO |
CMC1424S/1425S
|
On the screen is horizontal band. | Check of ic301, q401, q402, ic401, c407, r415, r416. | ||
| DAEWOO |
CMC1424-S
|
Closing the screen. it connects, gives a vertical line and does not open the entire horizontal line. | It is necessary to change the deflector coil and make adjustments. | ||
| DAEWOO |
CMC1424S
|
It turns on and doesn't open horizontally, just a thin line vertically and disappears. | Changed capacitor c317 105j (200v) in the horizontal ccto and it started working again. | ||
| DAEWOO |
CMC1423
|
When the device is connected to power, the power supply keeps arming and disarming without stopping. | Replace ic103 (kia78l05) which is near. to t001 (transf.chopper). An MC7805 regulator with higher current was used instead | ||
| DAEWOO |
CMC1418AD
|
One of the colors is bad.. | Check of ic801, q821-q824, q811-q814, q801-q804. | ||
| DAEWOO |
CMC1418AD
|
No width adjustment. | Ic202 e c212. | ||
| DAEWOO |
CMC1418AD
|
No line synchronization. | Check of d131, ic101, ic103, c104-c106, c111, r105, r112. | ||
| DAEWOO |
CMC1418AD
|
The size on height is not in rate and is not adjust vr204. | Check of ic101, q203-q205. | ||
| DAEWOO |
CMC1418AD
|
No plot. | Check of d321, ic101, q201, q202. | ||
| DAEWOO |
CMC1418AD
|
Without synchronization. | Check of ic502. | ||
| DAEWOO |
CMC1418AD
|
Vertical line in the video. | L105 e c126. | ||
| DAEWOO |
CMC1418AD
|
Not work a regulation of contrast. | Check of q401,q402, vr401, vr402, r403, c813, ic801. | ||
| DAEWOO |
CMC1418AD
|
Lack of synchronism. | Ic 502. | ||
| DAEWOO |
CMC1418AD
|
No image. | Check q805, q806, ic501, ic801. | ||
| DAEWOO |
CMC1418AD
|
Output voltage of power supply is not good. | Check c813, c814, r615, ic801. |