Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
EE3
|
Bank raster/no sound - osd ok | Z953 1.6a cct prot. has been uprated to 3.15a in sets incorporating sat rx | ||
| MITSUBISHI |
EE2 CT14MS1L
|
Stuck in av mode | Check for cracks around tuner lugs | ||
| MITSUBISHI |
EE2
|
Black line down lh side | R571 560r 1w o/c | ||
| MITSUBISHI |
CVC800
|
Colour - has hanover bars. | C307 (10uf) tant. | ||
| MITSUBISHI |
CTV2533
|
Destruction of line tr ( 2sd1877 ) int | Remove t551 retin & replace replace str59041 q901 | ||
| MITSUBISHI |
CTAV1B
|
Int reverts to st/by (aft 30mins) | Crt appears to have flashed over by spark gap - check aquadag earthing | ||
| MITSUBISHI |
CT37C2STX
|
St/by only | C959 470µ 16v & c956 2200µ 25v & check r956/ 986 for dry joints | ||
| MITSUBISHI |
CT37C2STX
|
Dead | Blown 5a wickman fuse from sec of chopper trfmr z950 | ||
| MITSUBISHI |
CT3703STX
|
No pic - ok thro' scart | Check for dry joints in if can | ||
| MITSUBISHI |
CT3703STX
|
E/w & width | Check r5005 / r5006 for dry joints | ||
| MITSUBISHI |
CT3703STX
|
Dead - loptr s/c | Loptr 2sd1879 replaced & c908 10µ 100v, c909 47µ 50v | ||
| MITSUBISHI |
CT3701TX
|
Dead & tripping | Dry joint on 47µ 200v cap in ht rail | ||
| MITSUBISHI |
CT3701TX
|
Dead | Ht rect d916 s/c by399 a good substitute | ||
| MITSUBISHI |
CT33C1STX AND S
|
Int sync | Drys on text pcb check plugs and sockets also check q7706 , q7707 , c7718 22uf 50v q7706 main suspect | ||
| MITSUBISHI |
CT33C1STX AND S
|
Int loss of sync | Dries on text board plugs / sockets or q7706 q7707 c7718 | ||
| MITSUBISHI |
CT33C1STX
|
Sync int | Vid i/p buffer q7706 jc501r or possibly q7707, c7718 22µ 50v | ||
| MITSUBISHI |
CT33C1STX
|
Dead with leds flashing int | C959 470µ 16v | ||
| MITSUBISHI |
CT33C1STX
|
Dead | C905 & c910 leaky causing q901 & d907 s/c - also check ic901 | ||
| MITSUBISHI |
CT32BW1B W1
|
Dead with no leds lit - quietley tripping | Check 2 current sensing res r907 and r915 in psu. they are 0.22r and 0.27r in parallel for hi res | ||
| MITSUBISHI |
CT32BW1B
|
Dead apart from pri ht | Replace strm6529 chopper chip, 0r22 res & check cct prots in psu sec |