☰

Philco Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philco
Results: 4838
Make Model Symptom Problem Solution By
PHILCO TPF2130
Blocked channel General password 7685 Type 7685 and then enter the menu and deactivate the function
PHILCO PC 1444
TV kept blurring the image and interfering with the sound (squeaky) Ceramic capacitor c 203 on the fi line, shorted Replace capacitor afonso Eletronica taquari
PHILCO TP-1452N
TV does not work when turned off and making noises at the power supply Capacitor,position,c913=1mf/50v I replaced it and plz ELETRONICA MEDEIROS
PHILCO PCM 1444,1446,2044,2046
Works normally with screen and LED blinking like a solution R713 100k open I replaced it and resolved antonio dos santos lima
PHILCO PCM-1444 -1446 -2044-2046
Running away from color, sometimes you want to scroll vertically but it's not enough to scroll the image half tremola C205 I replaced c205, 208, 702 solved antonio dos santos lima
PHILCO TPF29S4F
It doesn't turn on, it just stays on stdby, sometimes it sets up the power supply and sometimes it doesn't work, it seems like a bad contact but it isn't. 3.3v low supply Substituir q903(bc337-25) e zd902(zener 4,7v) NARDINHO
PHILCO PCS2952
CPH06 		Activating the protection and then turning it off and with +b180v with 260v Causes depleted width capacitor c711 and c712 klein
PHILCO PCM-2046
Blue screen, no sound but normal osd. C-722 470x16 FERNANDO S
PHILCO PCM-1444
Running away acor, or a hundred color pb, Zd504 5v1. can you put the dz4v7 it works ok GLUJ SAT Eletrônicos
PHILCO TP-1454
Tv inoperative Transistor fet switch shorted conducting and killing fuse Replace of the same jayjunior
PHILCO PCM
2046 		Out of sync 2.2uf/50v electrolytic capacitors near the ci one chip. Replace of the same jayjunior
PHILCO PC-1444/2044
No synchronization turning on. after a few minutes the image becomes normal. C-205, c-409 of 2.2x50 and c-722 of 1x50 (electrolytics) FERNANDO S
PHILCO PC-1444/2044
Severe noise in the sound, normal image C-722 = 470x25 FERNANDO S
PHILCO TP1454
Faulty vertical...horizontal output getting very hot Change the circuit ic601 tda9309.... place a 12r resistor between the base and emitter of the horizontal output transistor FUBULHA-PI
PHILCO PCM1444
CPH05 		Does not open the vertical, good ci, there is no 2.8 volts on pin 43 of the ic-501 Check if the r-802 12k resistor is open If said resistor is open, replace it. Paulo Sertel Itararé SP
PHILCO PCM1443
CPH05 		Horizontal K (again) C-709 10nx100v open (no capacity) Replace it with a new one and a hug Paulo Sertel Itararé SP
PHILCO PCM2043
CPH05 		There is sound, there is an image but the LED blinks and there is no voltage on the protector The r-713 resistor changed (interrupted) Substituir o r-713 100k Paulo Sertel Itararé SP
PHILCO PCM2043
CPH05 		LED flashes (standby) and seconds after switching on C-722 470x16 volts alterado Replace it with a new one, if resolved Paulo Sertel Itararé SP
PHILCO PCM2144
CPH05 		Tremulous image C-205 2.2x50 volts exhausted Replace the c-205 with a new one and readjust the trimpot p-201 10k Paulo Sertel Itararé SP
PHILCO TP14U56
Without image, with osd and sound D602 Replace d602 with leak joaomvjr