Philco Repair Tips

Search: philco
Results: 4810

Make	Model	Symptom	Problem	Solution	By
PHILCO	PH49F30DSGWAC	Does not turn on, no standby	Changed optical coupler uw2 and ci pwn uw1 killing the voltage.	Replace both components. the ci pwn is the ld7536.	NiloTech Eletro Eletrônica
PHILCO	PH4930DSGWAC	Does not turn on, no standby	Changed optical coupler uw2 and ci pwn uw1 killing the voltage.	Replace both components. the ci pwn is the ld7536.	NiloTech Eletro Eletrônica
PHILCO	PH42E53SG	Standby on, turns on, no backlight, does not turn off power	C122 na placa tcon	Replace with one of the same size	ToniTec
PHILCO	TV PH32M LED A4	Turns on sound and normal image after a few minutes it becomes silent.	Replace c823 remove q809.		Carlos Rocha.
PHILCO	PH21SS	Reduced frame voltage of 113v low or varying	Rp551 2k tripot oxidized or open defective	I replaced it for a 2k2 because I couldn't find a 2k one and went for the hug	orlando lott
TV PHILCO DE 29	TP29C21 PCIB0004 REV.	Defect was the power supply made a noise and did not arm, it was accumulating charge d915 with leakage	Defect in the primary power supply	Era d915	CLAUDIO ROBERTO
PHILCO	PHT660N	Does not turn on, low power supply, panel off	Capacitors with esr (they measure normal on the capacimeter but the esr meter shows the defect), change without testing e1, e2, e10 e9 e11 e31 e5 e3, e21, e26 open r20		HAHNRAHN
PHILCO	PHT660N	Does not turn on, low power supply, panel off	Capacitors with esr (they measure normal on the capacimeter but the esr meter shows the defect), change without testing e1, e2, e10 e9 e11 e31 e5 e3, e21, e26 open r20		HAHNRAHN
PHILCO	PTV50D60S	Doesn't start. only flashes standby LED	Short on the main board, killing the 5v supply. By injecting voltage into the shorted line, the processor would heat up.	RTD2968 processor replacement. As tsound is no BGA soldering, it is easier to find the processor and replace it. Another solution is to replace the main board.	GABSENS
PHILCO	PTV32C30D LED	I changed the board, it kept changing colors (rgb)	On the remote control press vol+ or vol-, or menu, or pause, or exit. in my case it was the exit key to unlock. Fits various Philco models		Eletrônica Cecé. Brumadinho MG
PHILCO	PH21M SS	When it turns on, the screen flashes and turns off. The stand by LED keeps flashing	2n5551 at position q802		Rildo Aranha
PHILCO	PH39E53DS	Burned out leds	Put the new bar and reduce the LED current	Remove resistors r44,r45,r46, leaving only resistors r47er48; some chassis already come without r44	Joao Bosco Sorocaba
PHILCO	PH49F30D	Tv sem backlight	Standard quote for replacing the LED bars, without even opening the equipment. requested part, when it arrived we went to install it, surprise, it wasn't the LEDs.	On the main/power supply board (this TV uses just one board) tsound is the backlight circuit with two sk320u diodes. one deldes was shorted. Both were replaced. Make sure to insert a diode with the same code, as they are ultra-fast diodes, a common 1n4007 diode will not work.	GABSENS
PHILCO	PTV 40E60SNC LED	Does not see wifi network - does not connect	Sem 5 volts no vdd da wi-fi board	The vdd voltage comes directly from the processor, so in this case I made a 5 volt point jammer and connected it to the Wi-Fi card! Note: disconnecting the original VDD wire from the p board does not return anything!	George Luís
PHILCO	PH39E37DSG	12v low pulsating and 24v normal	Replace dp9 diode		ELETRONICA RADIAL
PHILCO	PH42F10	Restarting	Keyboard keys keys		Cabeça
PHILCO	TP-2920	Sem video no av	Causa c731 r723		Carlos
PHILCO	PH32E32D	Tv philco ph32e32d cutting the sound or no sound	100ufx16v ca815 and ca804 replace solution	This TV arrived at my workshop without sound, I updated the software and resoldered the board in the audio processing area but it didn't solve the problem! So a friend gave me this tip that I want to share with you! defect, no sound or the sound is choppy!	GEMASI
PHILCO	PH32E32D	Tv philco ph32e32d cutting the sound or no sound	100ufx16v ca815 and ca804 replace solution		GEMASI
PHILCO	PH32U20	Doesn't start. 12 pulsating fountain	Change dp202 under the power supply heatsink.		Tec-Center