Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
21PT9467S
|
Lack of width or cushion | Q303 done replace | Tip/ any defect that appears on this chassis first rewrite the eeprom | valdir.é |
PHILIPS |
21PT9467/78
|
Fly with bubbles | Power supply with 116v q302 d5032 bu2527ax was used, replaced with 4.7/250v c411 not shown in the diagram, fly bsc 29-3807f was used bras alfa another brand does not adjust the convergence well, not even through the setup. | BRUSKE | |
PHILIPS |
29PT4631
|
With a stripe from top to bottom | R3493 6r8 1w | Replace | EletroClaudio Aguas Belas |
PHILIPS |
32PW8608
EM2E AA |
Faulty east/west (ew) circuit | R3483 1k smd next to photocoupler 7483 | Pingo | |
PHILIPS |
21PT5433/7BR
374121 |
Screen a little small at the top | I don't know | marcio | |
PHILIPS |
PT519A
|
Red screen and then turns off | The screen turns red and within a few seconds it turns off | jair f. dos Santos | |
PHILIPS |
14PT3131/78
|
Place with ten minutes off | 47 r open resistor 3403 | maurocelso | |
PHILIPS |
TODOS QUE BDS NA SAIDA VERTICAL
|
Only half of the top or bottom image | R3446 sup. r3445 inf. | ||
PHILIPS |
20PT4331
|
Does not include audio and video | Enter service mode (062596+menu) go to option and then to 0p5 enter the number 072 and exit by pressing the menu key and as soon as you exit, turn off the TV in the standy bay to record | Enter service mode (062596+menu) go to option and then to op5 enter the number 072 and exit service mode using the menu key turn off the device so that the replace is recorded in the standy bay and turn it on again | Julio Cesar |
PHILIPS |
21PT9467
|
Vertical, with thick strokes and closed about five cm at the bottom and top. | Electrolytic capacitors, c-315 and c-316, both 1000ufx25v. replace them, it's ok. | Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, Jataí-Go, |
|
PHILIPS |
29GX1898/78
|
Tall, vertical fountain burning!!! | 2512 capacitor with leak on the power supply plate!! | Replace "immediately" quickly and run for a hug. | TV TECNICA BRACEL |
PHILIPS |
14GL1019
|
Vertical half closed giving lines | Change the capacitors of the vertical resolder tda 8361 and around it change the green wire that goes to the +12 kinescope PCI to +8v | WARLEY CESAR | |
PHILIPS |
21PT9467C
SK4.1L CA |
Turning off as soon as the image appears | Zd303 with leak | Replace | eletronicaoeste |
PHILIPS |
29PT5642
L04U |
It doesn't turn on, only the red LED is on! | T7406 | Put bu908 or 508 | ÁdrianChapadãodoCéu |
PHILIPS |
29PT9467S/78
|
With sound without image, without high voltage beeping loudly | Transformer and lines switch | ||
PHILIPS |
20PT122A
|
LED is on but does not turn on. | C2551 e r34? no pino do +9 do flyback | ÁdrianChapadãodoCéu | |
PHILIPS |
20GL1044
|
Does not oscillate horizontally and makes a noise at the power supply | Cause: 22k r3501 open | klein | |
PHILIPS |
VARIOS
|
How to solve various defects on LCD and CRT TVs | <a href="http://www.electronica-pt.com/images/fbfiles/files/dicas_tv_philips.pdf" target="_blank"> dicas philips</a> | amram | |
PHILIPS |
PT3131
|
Risk of vertical retraces at the top of the screen and turns off by itself@@@ | C2460=68k on flay's side | Help yourself, leave your tip ass. arni | EETRONICA ARNI-L. LEAL- SC |
PHILIPSSCURA |
29PT552
|
Very dark image | Cause: 56k resistor 3482 open | klein |