Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
21PT9467/78
SK 4.1 |
No image, with normal characters and normal sound. | After changing the flyback, which was cracked, the TV had no image. | D302(1n4148) shorted. | ÁdrianChapadãodoCéu |
| PHILIPS |
29PT5642
|
Turns on and then turns off with horizontal stripes without an image and a bright point in the center of the screen when turning off. | Changing r3351/100r and 7330 tda-6107 turns on is normal, just adjustments. | I replaced these parts and it was beautiful. | Eronaldo |
| PHILIPS |
20PT228A/78R
L01.2L AA |
Sem audio, 6v pino 4, 0v pino 2 ic7902(mono) | C2905 (leakage or short) | Replace it | SADER |
| PHILIPS |
29PT5642/78
L04L AA |
LED flashes in this sequence 1 - 5 - 11 times, when it turns on, the board shrinks on the sides and turns off shortly afterwards | Photo 7513 | Replace it | SADER |
| PHILIPS |
29PT
|
Turning off error 11 | Tda6107jf | Replace ci tda6107jf | digital tec |
| PHILIPS |
PFL 3404
|
The lights turn on but tsound is no image | Clean the contacts of the flet that connects the PCI TCOM with the display. In my case it worked. good luck | Pedro ironei | |
| PHILIPS WIDE SCREM |
28PT6441/78R
|
TV doesn't turn on. It just stays on standby | C2511 | Replace the capacitor with a 100μFx50volt one. The curious thing is that some devices do not have this component. Just replace and smile! | tectron eletronica ipatinga |
| PHILIPS WIDE SCREM |
28PT6441/78R
|
TV does not come out of standby, turns on and goes back to standby | O capacitor c2511 | I checked the voltages of 3.3 and 6va, they were normal. however, on pin 2 of the ci 7520 tsound was not enough starting current for the +b 120v | Rogerio |
| PHILIPS |
14PT4131
|
Bad sound like a burnt out output | Capacitor de 220p c2861 | Replace | jtm eletronica |
| PHILIPS |
20PT3331
|
No sound or low volume | Place cond.electrol.100x25 parallel with d 6908(smd) neg. in k and posit. in a.(solved) | joaquim | |
| TV-PHILIPS |
21PT5435/78
|
Device burned by lightning | After redoing the burnt tracks I found that the device did not work even with normal voltages, that's when I checked that tsound was no 3.3v on pin 61 of the computer (tda9370ps/n3/a/1918) | Replace the computer and go for a hug | |
| TV PHILIPS 32´´ LCD |
32PFL 5604
-------- |
Does not turn on the stand-by, inoperative, has no power supply. | Cw2 shorted. | Cw2 de 220pf | Ademir tc |
| PHILIPS |
29PT658
|
No uhf signal | Service mode | Enter service mode and if op1 is 0, set it to 128 | |
| PHILIPS |
29PT658A
|
Poor width and no adjustment eww in the service menu | Adjust in service mode. | Service mode, "options" op 3 and replace to 128 or 164. exit service mode, turn off the TV, turn it on again, enter service mode again and see in the horizontal "geometry" part if the eww option appears, this adjusts the width | Edson Caeté |
| PHILIPS |
14PT4131/78
|
Low sound when it increases I heard it very softly | Capacitor 2444 470/16v replaced, the sound was excellent | MARCIO FF | |
| PHILIPS |
29PT4641/78
L04U |
When turning on the TV, 3 lines in red, green and blue appear at the bottom 5cm above the end of the screen and then turn off | D6457 smd em curto | Replace the same | Assolini |
| PHILIPS |
FWD798/55
|
No audio from surround speakers and center speaker | Interconnection cable between the main device and the sub-woofer box with broken leads | Redo the cable or replace it. | Jheliocavalcanti |
| PHILIPS |
CED228X/78
|
No voltage (12vdc) at the electrical antenna output | Resistor r113(2,2r x 1/8w) aberto | Replace the same. | Jheliocavalcanti |
| PHILIPS |
FWD798/55
|
No audio on sr channel | Capac.elet. c422(4.7mf x 16v) on the main board is open. | Replace it yourself | jheliocavalcanti |
| PHILIPS |
FWM 143/55
|
Inert cd mechanics | Ci/ la6548 defective | Replace of the ci/la6548 that controls all the mechanics of the same |