Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
29PT4635
|
Thin vertical stripe with drizzle | D6467 leaking | Replace without testing | antonio nobrega(patos pb) |
| PHILIPS |
21PT5433/78R
|
Image closed 5cm above, with retrace. | C2460, c2465 e r3444 | If after changing them, the sound disappears, replace c2444. | ÁdrianChapadãodoCéu |
| PHILIPS |
29PT9467
|
Burning horizontal outlet | Flyback with escape | ||
| PHILIPS |
21PT9467C/78
|
Closed vertical, line at the bottom | Right away I saw the ci tda4865aj stuffed, as I had the tda4863aj in stock, I replaced it and it worked | Ci replace | Eliel |
| PHILIPS |
14PT110A/78R
L7L |
Vertical closed, missing pulse voltage on pin 8 of tda 3653b | R 3406, 2k2 open resistor | Replace it and the TV is back to normal | Alfredo Jose Resende Neto |
| PHILIPS |
21PT5435
|
After being on for a while, it turns off. | If you've already done everything and changed what everyone said and it didn't work, disconnect pin 36 on the micro ehto and send the TV away. | CALIXSERVICE | |
| PHILIPS |
14GL1311
|
Low power supply, and it doesn't turn on. | Replace ts355 ,bc558. | ||
| PHILIPS |
20GX1659
|
Kind of out of tune | Change coil 5210 | ||
| PHILIPS |
14PT314A/78R
|
It goes into protection in seconds, you have to insist to see the glow with a vertical stripe. | Micho latch on the trail with the vertical exit | Just scrape and solder the ci pins | alecio dal pozzo |
| PHILIPS |
21PT6437
|
Dark screen, more with sound and characters. | R 3442 de 100k | ||
| PHILIPS |
21PT9467C78
|
Closed vertical. the deflection line at the top of the screen | Lack of negative voltage at the vertical output | Replace the resistor that feeds the negative voltage that comes from the fly back | |
| PHILIPS |
20PT3331
|
TV inoperative with primary power supply ticking.....ticking....ticking...., but when using the heat steam station on the plate it worked, but when turning off the TV and it cooled down, it no longer turned on, So that's when I started looking for the defect in parts, it was when I threw heat on the photo-coupler and the TV turned on... | It was the photo coupler, because it had to be replaced and the TV worked normally | ||
| PHILIPS |
20PT120A
|
Doesn't start. When you activate the control, the LED flashes a few times and comes back on. all normal voltages. | Capacitor 2442 (smd) with cracked or damaged solder. | ECJ | |
| PHILIPS |
20PT524
L9.2A |
Replace of the same | Q7400 bf 422 short base emitter | Replace of the same | |
| PHILIPS |
15PT136A/00
ANUBIS A |
Dark screen with sound | R 3296 (100Ω.) c.i. power supply tda 3504 | Grobio | |
| PHILIPS |
21PT5432/78
PT |
When it is on, it loses tune and comes back at the same moment and sometimes when it comes back on the image some characters appear as if it were resetting the memory. | Internally, the kinescope socket will spark, causing the computer to give a momentary breakdown. | Changing the kinescope socket is the same one used in Panasonic Philips tube devices | Helio Eletrosonic |
| PHILIPS |
21PT5433
|
With characters but without image with sound | 100k open resistor close to the flyback, r-3442 | joelton | |
| PHILIPS |
20PT3331
|
TV with primary power supply chirping ticking......ticking.....ticking, and it didn't stabilize the voltage kept oscillating and wouldn't turn on | The integrated one that is below the board in the primary power supply, the tea 1506 t, was replaced | With the replace, the TV was clean and started working normally again, as a precaution, replace the capacitors and resolder the chassis ok thanks | HELIOMAR |
| PHILIPS |
29PT4641/78
|
It makes it turn on but it doesn't turn on and when it turns on, colored lines appear at the bottom of the screen | C2484 de 10uf 100v e d6457 smd em curto no vertical | Replace | EletroClaudio Aguas Belas |
| PHILIPS |
14PT3131
|
Cold turns on turns off several times warms up stays normal | Power supply coupler photo. | je_eletronica |