Search: philips
Results: 14231
Make Model Symptom Problem Solution By
PHILIPS 29PT4635/78
White lines across the screen as if it were normal high sound screem and it doesn't turn off.l R3477 from 150r open. hndrsn
PHILIPS GR 1045...
GR1L1I-VA- RO3
After changing the fly back, only the LED and the 35V power supply blink. +12v protection activated Raise d6904, if it works, put a 13v one jasvan souza
PHILIPS 29PT4635
It turned on and then turned off, I changed it c2455 47u turned it on and held it but the screen is closed and serrated. Check the deflector as it makes a strange noise. Changing it is beautiful (dhf-2912pl) 1.8 to 2Ω horizontally and 13.6Ω vertically. Eronaldo(arteron)
PHILIPS 29PT554/78R
The TV sometimes turns on and sometimes doesn't, when it doesn't turn on the LED blinks continuously and the b keeps pulsing. The power supply does not activate, the slow starter does not work. C2540=100μF 25v was replaced, it was average in the test at 80μF, and c2530 of 1μFx100v was also replaced, I replaced the c2530 with a 2.2 x 100v one, I replaced the value of the original and it worked beautifully. Armando da Eletronica EvoluSom.
PHILIPS 14PT3336
Vertical closed Varicap Replace varicap ELETRONICA MAURI JUNIOR
PHILIPS 29PT558
L01.1L
Hits the relay and doesn't turn on. R3543 (82k) Replace joaomvjr
PHILIPS 29PT554A
Retrace and disconnect lines (without 180v) R3340 pci tube 0bs: measure d6335 sometimes with leakage and the r3340 burns again! Guto
PHILIPS 14GL1015
Low brightness, opaque image R3555 (27k) open Replace and run for the hug Eletrônica Staub
PHILIPS 21PT5433
Doesn't start Check resistor 3527 primary power supply amsmariano
PHILIPS 14PT3131/78R
Retrace lines at the top of the image 68nf/250v dry capacitor position 2460 As I didn't have a 250 volt one in stock, I replaced it with a 50 volt one since the vertical one works with low voltage. Helio Eletrosonic
PHILIPS 40PFL5605D/78
Total shutdown. D707 and d711. I used the uf4004 because the 1n4004 is not a quick cut and sound in Belém the material is complicated. I appreciate the tips from friends. ferraz, bruske and electronicaaeb. @gepe
PHILIPS 14PT4331
When you turn on the TV, the image is a little blurry and turns off. It looks like a tube defect. R 3444 amended Esper
PHILIPS 32PFL3605D
Does not turn on or light up normally PCI board defect I just replaced it and it was done! ELETRONICA AUTO TREVO
PHILIPS 21PT5433
Noise in the sound on stereo channels Configurar lista de option byte ▬ob1 = 0 (tuner alps), 128 (tuner philips) ▬ ob2 = 192 ▬ ob3 = 64 ▬ ob4 = 224 ▬ ob5 = 72 ▬ ob 6 = 0 ▬ ob7 = 80 eletronica ndn
PHILIPS 29PT5645
Doesn't work av Configure the following items in service mode 29pt5645/78 - op1 = 0 (alps tuner), 128 (philips tuner) - op2 = 160 - op3 = 128 - op4 = 164 - op5 = 250 - op6 = 42 - op7 = 0 eletronicandn
PHILIPS 29PT5645
Configure the following items in service mode 29pt5645/78 - op1 = 0 (alps tuner), 128 (philips tuner) - op2 = 160 - op3 = 128 - op4 = 164 - op5 = 250 - op6 = 42 - op7 = 0 eletronicandn
PHILIPS 21PT326A/78
Blinking led Replacement Flyback fco
PHILIPS 40PFL5615D/78
The television turned off by itself and wouldn't turn on again. Diode d911 shorted. replaced with 1n4004 for testing. I will replace it with the original later to avoid future problems. Ferraz
PHILIPS 32PFL3404
Does not turn on sometimes tsound is only sound Capacitor azul cf01 JARBAS A BRITO
PHILIPS 42PFL3604
Tsound is no 24 volt voltage at the power supply Na power supply r849 10Ω smd e diodo d5 comum smd Na fonte r849 10Ω smd e diodo d5 comum smd edgardsdo