Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 21PT9467/78
Changed width, characters, etc... with blurred image C327(4.7/250volt) changed Replace the same Jarbas (ELETRO-SERV)
PHILIPS 20PT324A
Has sound and no image works for 8 seconds and turns off Defective fly back. Perse
PHILIPS 20CT6255M/UV
The sizzling sound Coil s159. Perse
PHILIPS 20PT120A/78R
Vertical with noise at the top of the screen. Sorry, I posted the same defect but I changed the resistors. R 3407 Perse
PHILIPS 20PT120A/78R
Vertical with noise at the top of the screen R 3789 Perse
PHILIPS 20CT6558
Goes off with sound and if you increase the voltage on the screem grid it lights up but tsound is no image Open printed circuit track well below the b017 battery; caused by battery acid leakage. take a look. Perse
PHILIPS CTO
Dark screen C221 of 150uf can be replaced by a 220uf Perse
PHILIPS CTO
Problem with tuning S157 e s158. Perse
PHILIPS 14GX1618/78R
The screen is completely white, full of lines, it's as if the screen were fully open. R 3469 Perse
PHILIPS 20GL1045
Total inoperative D 345 Perse
PHILIPS THS3365X/78 DVD E RADIO
HDMI
Doesn't turn on without more b + in primary and secondary R937 1m open Lightning struck the electrical network and the power cable was connected. TEC TIOADRI
PHILIPS 40PFL5605D
After a few minutes of operation the screen becomes dark and with normal sound Bad inverter starting transistor and must be replaced with a bf 423 Replace the unknown transistor q800, put bf423 and replace pc701 Eletro Center
PHILIPS 29PT558A
Combines missing height with colored lines and shaking at the top of the screen. Replace capacitors 2473 and 2471, both 100k smd
PHILIPS FA-931
Noise at the outputs. I.c. lc7821 (placa selector in) Mário Tavares
PHILIPS 29PT5642
Normal power supplys tv doesn't flicker D6001 33v short Replace paulo-maceio/al
PHILIPS 21PT9467/78
SK 4.1
No image, with normal characters and normal sound. After changing the flyback, which was cracked, the TV had no image. D302(1n4148) shorted. ÁdrianChapadãodoCéu
PHILIPS 29PT5642
Turns on and then turns off with horizontal stripes without an image and a bright point in the center of the screen when turning off. Changing r3351/100r and 7330 tda-6107 turns on is normal, just adjustments. I replaced these parts and it was beautiful. Eronaldo
PHILIPS 20PT228A/78R
L01.2L AA
Sem audio, 6v pino 4, 0v pino 2 ic7902(mono) C2905 (leakage or short) Replace it SADER
PHILIPS 29PT5642/78
L04L AA
LED flashes in this sequence 1 - 5 - 11 times, when it turns on, the board shrinks on the sides and turns off shortly afterwards Photo 7513 Replace it SADER
PHILIPS 29PT
Turning off error 11 Tda6107jf Replace ci tda6107jf digital tec