Philips Repair Tips

Search: philips
Results: 14231

Make	Model	Symptom	Problem	Solution	By
PHILIPS	21PT5437/78	Vertical closed and turning off after a few seconds	Changing r9445 does not measure, it only changes during operation.		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT6456/78	When I turn it on in the morning, the screen becomes blurry, serrated, the focus doesn't work and keeps flickering and flickering, turning it on and off 5 minutes later, it works normally	Changing the socket on the tube plate and capacitor next to it from 1k to 2k2	And it worked normally again	WISLEN
PHILIPS	29PT 9467	Vertical closing at the bottom	Change the vertical output	Tda 4865aj	DEBIQUE
PHILIPS	14GL1310 GR1-AL	Completely gray screen with retractions.	R-550 = 4,7r x 1/2w ( pino 1 do fly-back ).		FERNANDO S
PHILIPS	21PT5433	Closed image with dash at the bottom of the screen	Q 7463 c546b	Replace´lo	Marcondes, jaicós-PI
PHILIPS	21PT6456	LED does not turn on	Horizontal output open = after changing it burned again after short flyback test	Changing horizontal output and flyback was ok	ELETRONICA MAURI JUNIOR
PHILIPS	21PT6456	Turns on appears vertical strip at the top of the screen turns off without image and sound	Picture tube killing screen voltage	Replace picture tube	ELETRONICA MAURI JUNIOR
PHILIPS	29PT4641	Vertical only opens at the bottom of the screen when you want or opens with a vertical strip at the top of the screen	Replace c2465 d6457	D6457 colocar no lugar 1n4148 = c2465 22x250v	ELETRONICA MAURI JUNIOR
PHILIPS	21PT6456 L03.1L	Vertically closed, opened 2 fingers and closed (pulsing)	R348 of 1Ω open	When I replaced it, it stopped pulsing and tsound was just a closed vertical line. I discovered an interrupted track that was supposed to connect the r3470 with the 2470 capacitor. This track passes under the 7466 smd transistor. I replaced the bc546 7463 and it opened halfway up, I then discovered that the 56n capacitor c2460 had a broken track when I reconnected the track everything was ok	JOSÉ GUSMÃO
PHILIPS	GL1019	+ b instead of 70 v it had 30 v and it didn't turn on	Believe me short sound output tda 7052	Replacelo	antonionobrega(patos pb)
PHILIPS	VARIOS MODELOS	TV doesn't work, keys don't work, control doesn't work with the factory message	89 keyboard and OSD on control		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT4641 L04U	Vertical open only the bottom	Smd resistor 3465 and 3464, the chassis only has one of the resistors		jedvaldo
PHILIPS	20PT3331	Turns off in a row	Cause: 1k 2318 smd capacitor defective		klein
PHILIPS	32PFL3403	Turns on and off randomly	Substituir as r 602,603,604	Place 01 1m resistance in place of the three	ELETRO CENTER
PHILIPS	150S	Turns on and off, sometimes holding down the keys works for a while and then turns off.	Defective digits	Replace all digits	Valmon
PHILIPS	29PT4631	Lines top of image	C2480 and c2487 obs. replace both		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT5642	The TV turns on right after it turns off and goes into protection, the image does not appear, but if you increase the screm, a vertical strip appears, not in the center, further down, but vertically closed.	R3606 auterated 56k resistor supplies the 5v to the hercules.	Resistor replacement.	play back
PHILIPS	20PT3331	When you turn on the TRC it turns green and then turns off (it goes into protection)	Poor contact on the r g b e board (in other cases it is the socket)	Soldered the whole board and it works normally	DIGITEC ELETRONICA Lambarí D'oeste -MT
PHILIPS	32PFL3404	With sound without image	Cf01	220n	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	14GL1319 GR1-R03	Weak video, no contrast, image varying, does not fix the effect	Open resistor r3215		Calixservice