Philips Repair Tips

Search: philips
Results: 14206

Make	Model	Symptom	Problem	Solution	By
PHILIPS	50PUG7625/78	Image with vertical lists across the entire screen (display) the lists increase every minute switched on.	Display defect	Put a Kapton tape interrupting the first 5 tracks of the t-con flat from right to left on the t-con board connector at the output to the display (flat cable on the right side)	LED TECH_CDS_DIAS
PHILIPS	40PFG4109	TV turns on, backlight turns on but no image	Short on the avdd line on the t-con, this display has t-con integrated into the v-con.	Inject voltage into the line (maximum 16v), remove the capacitor that gets hot from the board.	GABSENS
PHILIPS	46PFL7606	Tsound is no standby, u101 does not oscillate, no 3v3. .	Zd103 (7v5) with leak and/or altered	Replace diode without measuring. in the test it is ok	oskarala
PHILIPS	14PT3131	TV turns on closing image on the sides and turns off, horizontally.	It was the ic7515-defective photocoupler	I replaced and went for the hug	Eletronica Melo-Boa Viagem-Ceará
PHILIPS	FWP2000	Pulsing 12v power supply and it doesn't turn on, see c 729 of 10	C 729		Marcelo
PHILIPS	231TE4L-57	Restarting	U115 memory replacement
PHILIPS	32PFL6606D/78	Screen just stays blue	No		Fabiano
PHILIPS	FM663	Turns off shortly after turning on - does not turn on	It was setting up power supply protection because the 2 audio ci's were burned out. After the 1st repair, it worked for 15 days and didn't turn on again	In the first repair, the output tda's were replaced, and components at the power supply were tested, including the d15, which several reported shorting out and not allowing the device to turn on, and it was ok. After 15 days of normal operation, he returned to the workshop and this time the d15 (sb2100 diode) was shorted. After replacement, everything ok!	Hermes
PHILIPS	50PUG6654 00	No image	Capacitor board vcom shorted c67 smd	Smd c67 capacitor replaced	VALDENIR ( TECVIDEO )
PHILIPS	32PFL3404	After having changed all the bad capacitors, it continues to beep and turn off...	Leave the plate to soak in water with washing powder for 12 hours. then place in the oven or in the sun until completely dry. put the hug back...		Sérgio Eletrônica
PHILIPS	14PT3336	The switch comes with a closed vertical a little above and turns off	Open vertical line deflector coil.		JR Alagoinhas BA tec
PHILIPS	46PFL5615	Does not turn on, TV is inoperative, does not turn on standby	R106 2m2		Central eletronica
PHILIPS	14PT3131	When turned on, tsound is no image when turned off, the tube glows	47 k resistor 3491, just change it and thank God	I replaced r3491	Rogério TV
PHILIPS	FX30X	The display written philips turned on and stopped wsound it did not obey any command	The panel key was giving resistance on a high scale without being pressed, wsound the defect in mine was in the mode key, however I believe that another key could also cause this defect	Changing the front panel key, preferably all	LGD
PHILIPS	FX30X	The display written philips would turn on and freeze and it would not obey any command	Panel key that was giving resistance on a high scale even without being pressed, mine was the mode key, however I believe that another key could also cause this defect	Changing the front panel key, preferably all	LGD
PHILIPS	21PT6436/78 E OUTROS DA PHILIPS	Very low sound after some time it improves a little.	C 2444 of 470mf 19v	To replace. but you have to be very careful when replacing it, because tsound is a very thin track that goes from the positive pin of this capacitor to the vertical circuit. protection of this capacitor	Ferraz
PHILIPS	42PFL3604D	Turns it on, then turns off the lights, normal audio	I found 3 loose light bulbs and cleaned and resoldered them.	Everything worked perfectly.	Medeiros Barbacena MG
PHILIPS	21PT9467	Reduced vertical with retrace line at the top	220r2w r358 open or altered	I put a 220r 3w	orlando lott
PHILIPS	55PUG6513	Turns on with backlight on without image	T-com board, capacitor short near r202	Short capacitor near r202	jorge-Ivoti
PHILIPS	40PFG6309/78	Turn off the LED bars	In my case it was the primary power supply capacitor c9105 which was practically loose, with poor contact.		Mariano