Philips Repair Tips
Search: philips
Results: 14208
Results: 14208
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
14PT3336/78
|
TV turns on with retraction lines turns off in seconds | Change all the transistors on the kinescope PCI, even though they appear to be good | Case solved | otecnico |
PHILIPS |
29PT5642
|
Noise in the tube and very blurry image | Fly back ruim | After changing the kinescope socket, tsound was no other solution, I replaced the fly and the TV worked normally. | marcelo quinelatto |
PHILIPS |
14PT110A
|
Turns on and off and changes channels on its own | Replace the 7650 transistor (smd bc848) | somprimos eletronica | |
PHILIPS |
14PT212
|
Does not turn on or turn on standby | C 2447 shorted to horizontal output side | antonio nobrega(patos.pb) | |
PHILIPS |
20PT324/78R
... |
The screen brightens, but with lines, then turns off. | Lack of oscillation in the r.g.b output preamplifier transistors;..note: cold soldering. | All the pre and r.g.b output transistors were resoldered, and it was...beautiful. | Armando |
PHILIPS |
21PT 8467/78
S L O 3 1 L |
TV doesn't work | When this TV turned on, it made a hissing sound like a high leak and a line appeared in the vertical direction. Solution changed to r- 3445 of 1Ω, it was open. OK | jaironuness | |
PHILIPS |
33PT578
|
Turning off by itself and heating the horizontal output | Electrolytic capacitor c-2455 - 47mf/25v with changed capacity | Capacitor replaced | Eletrônica Carlos - Salvador |
PHILIPS |
20PT120A
L7L |
Normal image after a few minutes the image becomes drizzled and disappears. | Ic 1002 | Short the 100k r which is on pin 5 of ic 1002 | Igor Almeida |
PHILIPS |
14 PT 110
L7L |
TV turns on in service mode | Smd capacitor below the memory | Edson Peixoto | |
PHILIPS |
29PT6456
L04-UAA |
Works for +or- 1 min, taps the image and turns it off | Poor filtration at +b (160v) | Replace the cap 2552 (with less than 93μF) | MAIRES |
PHILIPS |
24PW6006/01
L01.1E |
Power supply without output voltages | Slightly low voltage on pin 1 of the ic7520 (power supply) | C2526(470n smd)com fuga | MeA |
PHILIPS |
20PT424
|
Does not turn on, the standby LED flashes | Power supply cap 100uf/25v change it you can measure it is good | I replaced it and the TV went blank | ELETRONICA ARNI - L. LEAL |
PHILIPS |
20GL1049
|
Just getting uhf channels. | Altered resistor3101(22k) | Luciano Fontes | |
PHILIPS |
29 PT 5645/78
|
TV didn't work primary power supply seemed to be fine but after the tr tsound was no b - primary power supply doesn't work | After a lot of head-scratching, a 82k secondary 3575 resistor was opened | ELETRÔNICA NYLSOM - |
|
PHILIPS |
20PT3336/78
|
Does not enter the av and tsound is no sound | Memory replace | Obs. I replaced it 3 times and recorded it f'' | Neguinho(itapevi) |
PHILIPS |
21GX1668/78R
|
Tv doesn't work | Check r3511(24k) altered value | You can replace it with a 22k one | almicrrc |
PHILIPS |
14GX1610
|
Stop without +b | Replace do flay back at 2079/b4 | bt | |
PHILIPS |
20PT424A/78R
L9.2A |
Stand by flashing quickly | Replace capacitor 2530 and 2540 | somprimos eletronica | |
PHILIPS |
14GL1310
|
Buzzing in the speaker without sound | Capacitor 140 (ceramica 22k) | ||
PHILIPS |
29PT558A
|
Does not oscillate | 3491 - 10k | silva2 |