☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14232
Make Model Symptom Problem Solution By
PHILIPS FW M355/22
Without audio outputs on speakers, with audio on phones Pa power supply (AN7830a pin 1) w/ 36v instead of 16.7 Mosfet transistor 7302 (which regulates the 16v7) in dc. jose luis calcada
DVD PHILIPS DVP3142
Engine doesn't turn, it's not the engine Solution to change r76 on the mpg plate, very common in this model fernando ferreira da silva
PHILIPS 14PT3131/78R
PT3131 		Green screen, with retrace and disarming Resistor connected to transistor 7310 on the kinescope PCI (open/check) Replace of the same vinicius
PHILIPS FW-M912
Does not turn on, tries to turn on, it seems that the relay does not arm or the relay keeps vibrating Faulty relay t904 BRUSKE
PHILIPS 29PT4640/78
Vertical closed + or - 4 cm at the top and bottom with wavy lines from the middle to the top about 15 cm on the screen I replaced the c2252 1n that goes on pin 17 of the computer and it worked Sidney Alves
PHILIPS 29PT4635
Noise in the horizontal output stage sometimes turns off C2455 47/25v Capacitor replaced
PHILIPS 20PT122A/78R
Image with horizontal pole bending image Transistor 7440 bc 847 Replace of the same eletronica poleza
PHILIPS 25PT5322/16
MD1.2E AA 		Does not stop tuning, and the tuned channels have sound but with a distorted image Coil 5114 (50131) Bobune is on plate 8211 015 0967 4 JOAQUIM CUNHA
PHILIPS DVD3124
Don't read Engine does not turn 1r resistor connected to pin 12 of the open driver p
PHILIPS 20PT3331
TV with the top part of the vertical partially facade and with lines of retraces The capacitor c2460, 83 or 83 nf, was replaced and the problem was resolved As a precaution, also replace capacitors c2446, c2465, c2463, heliomar
PHILIPS 20PT534
Oscillating weakly with reduced frame I changed the eprom memory and the device worked normally again Memoria eprom asr
PHILIPS 14GL1313
Tsound is no image, it just chirps very softly 22k resistor chasis (3501) Change the res: from (22k) eletronica ceara
PHILIPS 20GL1042T
Tsound is sound and no image when powering the esklim the screen turns green with a defect retraction line and the ci tda3565 chas:(ic260) Replace the same eletronica ceara
PHILIPS 14PT314A/78R
With drizzle and no image on pin 8 of the varicap tsound is 32v replace the varicap Change the varicap. eletronica ceara
PHILIPS 20PT3331
Closed image on the top side about 3 fingers plus about 20 white lines below the black band downwards the normal image to solve the problem replace 2 capacitors chas: (2465) 10uf 160v or another chas: (2446) 470uf 16v ok? ?? Replace the 2 capacitors eletronica ceara
PHILIPS 14PT110A
L7L 		It didn't turn on, it stayed on standby, when I pressed the channel button it flashed several times very quickly Tsound was a lack of 9v voltage coming from pin 5 of the fly, 1Ω resistor 3499 open and transistor 3480 bc337 shorted Romolo
PHILIPS 20PT3331
I'm sound Good friends, this TV had no sound, normal image, change the capacitor c444, ok? MACIEL CEARA
PHILIPS 14PT218
L01.2L 		Stopped, inoperative. totally dead. Power supply. power supply regulator 7520 (tea1507) and photo coupler 7515 (tcet1103(g)) After changing the regulator, the power supply worked, however, it had 130v at the +b of the fly back and would not start. Noting that the photo coupler seemed to be fine but, after replacing it, the TV worked normally. Tec Video
PHILIPS 14PT100G
Vertical closed In this case it was the 3412 (22k) open resistor fernandocamarques
PHILIPS 21PT4428/16B
MD1.11E AB 		Without image and sound, dark section and at the end of the lower limit a horizontal section Fusivel 1463; d6463 (byv27-400) We don't have +29v vertically joaquim cunha