Philips Repair Tips

Search: philips
Results: 14232

Make	Model	Symptom	Problem	Solution	By
PHILIPS	21PT5437/78 L03.1L AA	Alloy with closed vertical	1r resistor position 9445	So replace	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	20PT3331 L03.1	Same Audio, Som Chega Ate R3903	Dz 6908 tsound is no point in testing, you have to change it		Elias2305
PHILIPS	29PT4641 L04L AA	After 15 s, with image, it turns off. LED flashes 11 times, indicates beam current problem.	Lifting the r 3451, the TV is firm, but tsound is no brightness on the screen. After checking the circuit, the 680k smd resistor (3473) was less than 100k. I removed the 9488 jumper and replaced it with an 820k resistor.	Ready, just call, make the necessary adjustments, and run for the hug!	Luna
PHILIPS	20PT3331	The device turns on with the symptom of a weak tube, and with a small ripple on the screen, 2 seconds after turning off. primary power supplys with normal measurements.	Capacitor c2444 with low capacitance. generates a reduction in dc level, consequently drops the voltage that feeds the kinescope filament, it is advisable to change the resistors 3444 and 3443 as for this reason their values drop by more or less 2Ω		LOIMA SILVEIRA .sta. tereza RIO
PHILIPS	20PT3224/78R	Linearity interacting with the image	Electrolytic 2431 2.2 uf		ELETRONICA ROCHA
PHILIPS	PT122A	It has+and does not oscillate, but remains stuck. Channel key starts hiccups and heats up horizontal output	Fly back		matieski
PHILIPS	PT3336	Has +180 volts dark screen with no image	100k burnt micro resistor near playback		Antonio Sansio
PHILIPS	14PT3336 L03.6L	Does not oscillate and always stays on (with the LED on)	Resistor 3445 1r	Replace if opened or altered	Mayeu
PHILIPS	29PT4631/78R L01.1LAC	No sound no plot	Replace: horizontal output transistor that was shorted, t-7461, 7463 and c-2455 and touches the screen	Note: The relay keeps switching on and off. It only works properly after touching the screen.	Conscerta
PHILIPS	29PT4631/78R L01.1LAC	No sound no plot	Horizontal output transistor,t 7461 and 7463 and c-2455	Thank you all for the tips, they were worth it.	Conscerta
PHILIPS	29PT4631/78R ?????	No sound no plot	Horizontal output transistor,t 7461 and 7463 and c-2455	Thank you all for the tips, they were worth it.	Conscerta
PHILIPS	21PT6456 L03.1	No image and clicks on the flyback	Q 7462	Replace o transistor bc 587b	adimael
PHILIPS	MENU CURSOR 14GL 1045	White screen or image out of focus	Cable tube socket	Replace	IRIBERTO
PHILIPS	21PT5435	TV doesn't turn on	Horizontal output short, when I changed the horizontal output, the TV turned on with more ripple in the image as if it were a cap. duplicator	I fixed the processor and problem solved	eletronicaapolo
PHILIPS	FW C 270/19	After being replaced, the output kept turning off after a few minutes.	D 6555	Removed d6255 the micro system started to work normally	severino ramos
PHILIPS	28PW6515 A10	Sound sometimes doesn't work	Pin of the ic7064 intermittent internally, to avoid its replacement, disconnect this pin from the circuit. note: the function of the control's mute key stops working, it does not cut the sound		Oliva
PHILIPS	20PT324A	Turns on, after a few seconds it goes to stand by	Replace all transistors and diodes on the kinescope board	If possible, replace the board	eletronicaapolo
PHILIPS.	20 GL1346/78R	TV does not tune channels, same problem as the previous tip.	But the reason for this tip was r3956=10k, which was also open.	It was replaced and it was... ok.	Armando da Eletrônica só Tv.
PHILIPS.	20 GL1346/78R	TV does not tune channels.	R3958=18k aberta.	It was replaced and it was... ok.	Armando da Eletrônica só Tv.
PHILIPS	20 GL1346/78R	TV works when cold for up to half an hour, then it stops, the LED just keeps blinking	R3348=11k changed to 15k.	It was replaced and it was... ok.	Armando da Eletrônica só Tv.