Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	29PT5645	Don't care!	C2411		Andrade
PHILIPS	FWM417	No audio	Q601, tl431		Andrade
PHILIPS	25PT5541 L04U	Oval side, horizontal unregulated	D6404 shorted		Andrade
PHILIPS	20PT220A	Closing on the side and turns off	Q469	Replace without testing (there is no point in measuring it, replace directly)	MARCELO RODRIGO QUINELATTO
PHILIPS	20PT220A	Does not turn on, standby LED is on	C2442 (smd)	Resolder or replace if necessary.	MARCELO RODRIGO QUINELATTO
PHILIPS	20PT3331	Image frame reduced and turning off	Power supply coupled	After spending hours working I decided to replace, solving the problem	BETO ELETRONICA
PHILIPS	21PT6456	Vertical closed and turns off	Diodo de 33volts 6001 zener		MACCELETRONICA
PHILIPS	20PT3331	Turning off between 5 and 10 minutes	Change transistor- 7463 (c - 546/b) without measuring. note:. transistor - c 547/b can replace it		BARRETO CRUZ
PHILIPS	21PT5437/78	Vertical closed and turning off after a few seconds	Changing r9445 does not measure, it only changes during operation.		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT6456/78	When I turn it on in the morning, the screen becomes blurry, serrated, the focus doesn't work and keeps flickering and flickering, turning it on and off 5 minutes later, it works normally	Changing the socket on the tube plate and capacitor next to it from 1k to 2k2	And it worked normally again	WISLEN
PHILIPS	29PT 9467	Vertical closing at the bottom	Change the vertical output	Tda 4865aj	DEBIQUE
PHILIPS	14GL1310 GR1-AL	Completely gray screen with retractions.	R-550 = 4,7r x 1/2w ( pino 1 do fly-back ).		FERNANDO S
PHILIPS	21PT5433	Closed image with dash at the bottom of the screen	Q 7463 c546b	Replace´lo	Marcondes, jaicós-PI
PHILIPS	21PT6456	LED does not turn on	Horizontal output open = after changing it burned again after short flyback test	Changing horizontal output and flyback was ok	ELETRONICA MAURI JUNIOR
PHILIPS	21PT6456	Turns on appears vertical strip at the top of the screen turns off without image and sound	Picture tube killing screen voltage	Replace picture tube	ELETRONICA MAURI JUNIOR
PHILIPS	29PT4641	Vertical only opens at the bottom of the screen when you want or opens with a vertical strip at the top of the screen	Replace c2465 d6457	D6457 colocar no lugar 1n4148 = c2465 22x250v	ELETRONICA MAURI JUNIOR
PHILIPS	21PT6456 L03.1L	Vertically closed, opened 2 fingers and closed (pulsing)	R348 of 1Ω open	When I replaced it, it stopped pulsing and there was just a closed vertical line. I discovered an interrupted track that was supposed to connect the r3470 with the 2470 capacitor. This track passes under the 7466 smd transistor. I replaced the bc546 7463 and it opened halfway up, I then discovered that the 56n capacitor c2460 had a broken track when I reconnected the track everything was ok	JOSÉ GUSMÃO
PHILIPS	GL1019	+ b instead of 70 v it had 30 v and it didn't turn on	Believe me short sound output tda 7052	Replacelo	antonionobrega(patos pb)
PHILIPS	VARIOS MODELOS	TV doesn't work, keys don't work, control doesn't work with the factory message	89 keyboard and OSD on control		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT4641 L04U	Vertical open only the bottom	Smd resistor 3465 and 3464, the chassis only has one of the resistors		jedvaldo