Philips Repair Tips
Search: philips
Results: 14245
Results: 14245
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
CP110
|
No picture at 1st - then low contrast. | C2670 & c2621 dried up. | ||
| PHILIPS |
CP110
|
No pic sound pulsing | Ht pulsing & low 100µ cap on psu sub panel | ||
| PHILIPS |
CP110
|
No pic for 5mins ripple on lt + ht when off | Tr7670 cnx62a optocoupler | ||
| PHILIPS |
CP110
|
No pic at sw on - gradually improving with time (in chassis with tr7672 fitted) | Excess ripple on 140v line - c2670 & c2621 dried up (22µ 50v) or cnx62a tr7670 opto coupler | ||
| PHILIPS |
CP110
|
No picture - sound ok | Eht & a1s gradually appeared with time - c2621 22µ 250v | ||
| PHILIPS |
CP110
|
No pic 1st few mins when it comes on looks low | Check c2670 , c2621 both ( 22uf ) 250v | ||
| PHILIPS |
CP110
|
No ew correction. | R3599 ( 47r , 1/8w ) on crt base. | ||
| PHILIPS |
CP110
|
No ew correction & reduced width. | C2613 ( 390nf ) o/c. | ||
| PHILIPS |
CP110
|
No e-w corr after loptx replacement | R3599 47r o/c (on crt base) tr7601 or 7600? bf819 s/c c-e | ||
| PHILIPS |
CP110
|
No e-w corr | Components on crt base tr7600 running hot - tr7601 bc558 s/c, r3588 15k, r3587 1k8, r3599 47r all charred. c2589 33µ leaky | ||
| PHILIPS |
CP110
|
No display the 140v ht only 60 -80v | 7738 6v reg tr bc558 o/c | ||
| PHILIPS |
CP110
|
No display , 140v line low at 60-80v | Transistor 7738 ( bc548 ) 6v reg | ||
| PHILIPS |
CP110
|
No display | 10mfd 350v ( right side by lopt ) | ||
| PHILIPS |
CP110
|
No colour. | Check/replace c2265/2266 - 100nf. | ||
| PHILIPS |
CP110
|
Modification | Modification the rc5 receiver 4822 212 22746 is not available anymore. for that reason the circuit diagram, pcb layout and partslist is published in service information cp110 97.01 codenr. 4822 727 21554 | ||
| PHILIPS |
CP110
|
Memory loss of some pre-programmed programmes. | After reprogramming other pre-programmes disappear after some weeks. problem may occur in areas with heavy spikes on the mains in sets without peak voltage protection panel (sets with serial numbers <ag03 or qg13). problem can be solved by adding the pe | ||
| PHILIPS |
CP110
|
Lower half of picture cramped with lower half missing. | Check r3572 (1.5Ω) open circuit. this resistor is connected between the emitters of the frame output transistors. | ||
| PHILIPS |
CP110
|
Low ht at sw on (120v instead of 143v) | Sound 'stuttery' - c2890 100µ 50v on stand up panel on psu hi esr | ||
| PHILIPS |
CP110
|
Lines swirling across pic & no stopping in chan search | C2671 1500µ 15v smoother | ||
| PHILIPS |
CP110
|
Line tearing | Tr7542 bc857c s/c |