Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
CP110
|
Text - flickering. | Replace d6673 ( byv95a ) | ||
PHILIPS |
CP110
|
Striations lhs | D6630 o/c | ||
PHILIPS |
CP110
|
Spare part information | Spare part information only for 25", ag..9047 and ag..9048 in a number of sets the darkglass crt has been replaced by a light crt. for service the darkglass can be used. it is recommended to add r3488 47k. | ||
PHILIPS |
CP110
|
Sound but no pic , eht and heaters ok. may be only | Cnx62a optocoupler causing excessive ripple on lt and ht lines | ||
PHILIPS |
CP110
|
Sometimes sound gets louder | Ic7840 (4822 209 72038 mask 8188 or 4822 209 73665 mask 8189). | ||
PHILIPS |
CP110
|
Sometimes no sound, no picture | Replace ic 7840 (tmp47c432ap-8188; 4822 310 31849) or (tmp47c432ap-8189; 4822 310 31851) important: mount the metal shielding with earth to r 3276 | ||
PHILIPS |
CP110
|
Set starts but as picture appears trips violently | Degaussing positor us | ||
PHILIPS |
CP110
|
Set pulses on and off gradually staying on longer | Try tea1039 and optocoupler if still faulty check 15v protection pcb near chopper tx and change 100uf capacitor | ||
PHILIPS |
CP110
|
Set intermittently tripping and/or reverting to channel 1. | Check all spark gaps on crt base. resolder aquadag lead to chassis. | ||
PHILIPS |
CP110
|
Servicing the cp110 chassis | See tv mag jun 1993 | ||
PHILIPS |
CP110
|
Scart o/p has no synch with lines/interference - ok on rf | Check for dry joints in psu, field & lop stages. caps 2075,2072 10u & 2073 33uf = 12v decoupling on sw ic | ||
PHILIPS |
CP110
|
Repeated failure of the supply | Mount a resistor in parallel to coil s 5656 (39Ω; 4822 050 23909). check/replace r3655 - 22Ω, and c2660 - 1uf at 250 volts, polyester type. check resistor r3660 - 0.1Ω (4822 113 80429). | ||
PHILIPS |
CP110
|
Reduced width | Check c2620 ( 22nf ) r3599 ( 47r ) r3629 ( 1m ) r3639 ( 47k ) | ||
PHILIPS |
CP110
|
R/c has low gain | C2967 100µ 10v in r/c receiver | ||
PHILIPS |
CP110
|
Pulsing in and out of sby untill warm | Check small subpanel for faults esp 100mfd | ||
PHILIPS |
CP110
|
Pulses in /out of st/by at sw on | 100µ cap on separate over volts prot panel for 15v supply | ||
PHILIPS |
CP110
|
Psu trips after rebuild | Tr7727 bd438 in opto coupler cct | ||
PHILIPS |
CP110
|
Power supply starts slowly (after 1 min) | Check c2690 (100 uf 63v; 4822 124 40255) located on over-volt sub panel | ||
PHILIPS |
CP110
|
Power supply destructs or does not operate; but11af failure. | * check/replace: ic7669 - tea1039 codenr. 4822 209 83104 t7665 - but11af codenr. 4822 130 42679 t7666 - bc337 codenr. 4822 130 40855 ic7670 - cnx82a codenr. 4822 130 10025 * check if damaged or changed value resistors 3658 and 3659 * change c2 | ||
PHILIPS |
CP110
|
Power supply destructs or does not operate; but11af failure. | Check/replace position - 3653, and bridge rectifier d6657/8/9/60 - byd14j; 4822 130 31933. |