Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
CP90
|
Brightness level change in a/v mode | It is possible that some video equipment will provide a cvbs signal slightly in excess of the 1 volt peak-to-peak level required. this will cause a change in brightness levels when switching between external a/v mode and an rf signal which some viewers m | ||
| PHILIPS |
CP90
|
Blank raster after fitting new loptx | C2098 0µ47 or 1µ o/c | ||
| PHILIPS |
CP90
|
Blank raster - no sound or response to r/c | No 11.5v at thyristor 6726 in st/by cct as d6733 bav19 o/c | ||
| PHILIPS |
CP90
|
Audible hum in standby mode | A production change has been introduced increasing the value of c2661 from 33nf to 100nf (code no. 4822 121 41689). | ||
| PHILIPS |
CP90
|
95 volt varying with contrast level. | Check/replace d6665 - 1n4148 (4822 130 33939), r3665 - 4.7Ω safety (4822 111 30499). | ||
| PHILIPS |
CP110 MK2
|
Dead set aft an hour or two | F1653 1.6a wickman fuse o/c on separate overvolts trip panel - caused by cnx62 opto coupler | ||
| PHILIPS |
CP110 27CE3291/15B
|
No blue | Ic 7260 tda 3562a . also replaced 2408 cap 6,8 uf 63von crt pcb and cap 2633 100uf 25v | ||
| PHILIPS |
CP110 25CE6570/05B
|
Display erratic - int shows e1 | Replace µp ic7840 (tmp47c432ap-8189) | ||
| PHILIPS |
CP110
|
Won't go but11af trying to work | D6672 on secondary sc | ||
| PHILIPS |
CP110
|
Won't change channels from front buttons or someti | Switch membrane or poss connecting socket | ||
| PHILIPS |
CP110
|
Width - lack of - r3599 overheating. | C2613 ( 390nf ) o/c. | ||
| PHILIPS |
CP110
|
When switching to another transmitter the picture becomes blue. | R3049 an if module was 270kΩ becomes 330kΩ. | ||
| PHILIPS |
CP110
|
When set is cold, lines are tearing out | Replace c2633 (100 uf 4822 124 20735) | ||
| PHILIPS |
CP110
|
Verticals rippling | C2633 100µ | ||
| PHILIPS |
CP110
|
Verticals ragged when cold | C2633 100µ 25v | ||
| PHILIPS |
CP110
|
Vertical lines, screaming psu & dark grey raster | D6067 3v9 zener leaky | ||
| PHILIPS |
CP110
|
Txt flickering - tuner drift | D6673 byv95a 9v rect | ||
| PHILIPS |
CP110
|
Txt - letter at far right of each page faulty | Upd4364 rom chip in txt cct | ||
| PHILIPS |
CP110
|
Tuning - drift & flickering. | Replace d6673 ( byv95a ) | ||
| PHILIPS |
CP110
|
Tries to start then shuts down | Tr7666 bc 337, tr7671 bc327-16, r3628 18r |