Search: philips
Results: 14210
Make Model Symptom Problem Solution By
PHILIPS CP110
Power supp runs but no eht , display shows " 88" , a D6901 ( after replacing backup battery )
PHILIPS CP110
Poor start up from cold C2690 100µ 50v on overvolts sub panel
PHILIPS CP110
Poor remote range C2967 100uf 10v o/c inside remote can
PHILIPS CP110
Pincushion distortion. Check/replace c2610 - 7.5nf 2 kv 4822 121 43065
PHILIPS CP110
Picture pulses on and off Tr7413 or r3415 470k on tube base
PHILIPS CP110
Picture flashes cyan or green when warm R3415 on tube pcb 470k
PHILIPS CP110
Picture blinking (during the first 30 seconds). Transistor 7413 (4822 130 40937) or r3415 on picture tube panel is defective.
PHILIPS CP110
Pic flashes on & off at sw on, gradually improving Degaussing therm or r3415 470k o/c on crt base
PHILIPS CP110
Pic flashes Check r3415 470k & r3412 180r on crt base for o/c
PHILIPS CP110
Pic flashed cyan every few secs R3415 470k connected to 200v supply
PHILIPS CP110
Patterning on all chans Appears to go past stn when tuning slightly - adj if coils (bottom one nearest edge of pcb gave most improvement)
PHILIPS CP110
Page 811 appears spontaneously Decoder selects page 811 and blocks mount new up (ic 7800) mab 8461p/w196 (4822 209 62479) on txt-decoder.
PHILIPS CP110
Overmains panel Overmains panel --------------- a production change was introduced in october 1989 adding an overmains panel (1006) to the sops circuit. with this change resistor r3661 is deleted from the main panel and incorporated in the new panel. code no. for the
PHILIPS CP110
No teletext. Ic tmp47c432ap-8188 fitted instead of -8189 or vise versa.
PHILIPS CP110
No sync & wavy pic If module - tda2579 chip dry jointed & check elect caps.
PHILIPS CP110
No sound/pic with "f1" in display No line osc - no supply pin 12 sync/if module; crack in print by loptx; also check tr7739 bc548 o/c
PHILIPS CP110
No sound/pic aft replacing memory battery "88" displayed - with faint small, blank raster with hum bar - ok with battery removed - d6901 faulty
PHILIPS CP110
No sound. Check/replace r3672 - 1Ω (4822 111 30483) safety, feeds 25 volt rail.
PHILIPS CP110
No sound. Ic tda8415 on nicam pcb.
PHILIPS CP110
No sound or raster - shows f1 in display No volts on audio chip. r3672 1r safety res o/c (under standoff panel near chopper tfmr)