Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
14PT218A
|
With black band at the bottom of the screen, traces at the top and no sound | First make sure you have inserted the speaker plug into the correct input. If you didn't put it in the wrong entry, it's memory. | MB ELETRONICA | |
| PHILIPS |
42PFL3604
|
Does not turn on, red LED | PCI micro short | Pablo | |
| PHILIPS |
14GL1310
GR1.AL |
No vertical sync and no audio | Ssa0, shaqqkh | Replace without measuring | Pablo |
| PHILIPS |
25PT5541
|
Turns on, white screen, turns off after a few seconds | RGB IC, resistor on 200V line open. | Pablo | |
| PHILIPS |
32PFL3403 42PFL3403 42PFL5403
LC8.1L LA |
Blown fuse, won't turn on. | D802 and q801 short | Pablo | |
| PHILIPS |
29GX1899
|
Does not tune channels | Absence 33v | R 3292 open 15k | ALEX/FETTER |
| PHILIPS |
29PT4641/78
|
White lines at the top of the screen | C2465 100v 10uf | fco | |
| PHILIPS |
32PFL3404/78
|
Does not work/noise at power supply | Capacitor cb1 with low capacitance or exhausted | Replace cb1 - 4.7μF/450v | ANTONIO DONIZETI DA CRUZ |
| PHILIPS |
29PT552
|
The TV has no color and when you change channels it beeps and the horizontal output burns | Defective memory because when changing channels it changes the horizontal frequency causing the bu1508 to burn | I just replaced the memory and I'm fine | charles cbs |
| TV PHILIPS |
20PT424A/78R
L9-2A AA |
No sound, it doesn't amplify | Dz 6953 3.3v and ci7953 pay close attention to the end of the sound ci letter, if it is mono it has to be tda7056b, do not put the end a | cunha753 | |
| PHILIPS |
FW-380C
|
The CD doesn't work, it accepts selection for the CD but it is inoperative. Some key lights are off. | Replace of 7404, 7405 and 7406 hfe4094 smd on the panel | joaomvjr | |
| PHILIPS |
21PT9467
|
Device after some time on, closes the vertical after about 1 hour | Deflector opening one of the windings beneath the glue. | It was very difficult to recover the deflector. I had to replace it. | marcelo lurahy |
| PHILIPS |
21PT5433/78
|
No, it doesn't oscillate. But if you measure the frequency, is it 15.7 kHz? | R 3490 changed. Depending on the changed value, several defects will occur in the horizontal | R3490 3k3 | mecinhor7 |
| PHILIPS |
21PT9467C
|
I had already changed the band's integrated varicap micro memory, etc., a terrible defect only on channel 13, when it was cold, it was out of tune and then when it warmed up, the image improved, it was a more solved puzzle. | And just remove the disk capacitor from the plate that is close to the 100k micro c828 | Remove c828 from 100k disk | carlos de maranguape1 paulista-p-e |
| PHILIPS |
21PT6456
|
With sound without image | R-3442 de 100k , proximo ao flay-back . | Resistor aberto no pino 1 do flyback .... | JOELTON |
| PHILIPS |
14PT3132/78R
|
Has audio characters and a dark screen | R3442 open abl line | samuel leite | |
| PHILIPS |
HPS-2991FS
|
TV burned out the bu 2520dx so far so good, so I bought another one I put it in its place but it didn't work it just oscillated but didn't produce high voltage, checking all the voltages which were ok after so much inspection I decided to put another one from an old board a bu 1508 then the TV worked | Moral of the story, the bu I bought looked good but was bad internally, so sound's a tip guys, be careful with your bu lol | ||
| PHILIPS |
TV PHILIPS GX 1899/78
|
No weapon power supply | Replace c 2420 c 2411 and c 2418 | JCARLOSMART | |
| PHILIPS |
29PT558A
|
Without sound, but with image. | Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails. | Bridge. | lou |
| PHILIPS |
29PT658
|
No sound, but normal image. | Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails. | Make a bridge. | lou |