Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
FWM593
|
Sound i am | R611 e tr q632 | Just replace it and move on to another one. | eletronica vieceli |
| PHILIPS |
20PT122A
|
Av doesn't work | Enter service mode ground pin 1 memory | Replace to av 01 | ELETRONICA MAURI JUNIOR |
| PHILIPS |
CTN-BB
|
Does not do standby | Replace smd transistor position 7601 | Ruyzovich | |
| PHILIPS |
CTN-BB
|
Red image with return lines | Replace smd transistor position 7644 | Ruyzovich | |
| PHILIPS |
CTN-BB
|
Does not start LED blinks | Replace 12Ω resistance in power supply position 3521 | Ruyzovich | |
| PHILIPS |
CTN-BB
|
Does not adjust contrast | Replace resistance (3460) of 10k | Ruyzovich | |
| PHILIPS |
CTS-AA
|
Vertical problem, image shrinks when changing scene | Change r3461 from 8k2 | Ruyzovich | |
| PHILIPS |
CTS-AA
|
Image stretched to the right side and does not fill both sides horizontally and does not tune | Replace o ic stv2246c | Ruyzovich | |
| PHILIPS |
20PT529A/78R
|
It turned on after it got too hot or didn't turn on at all | Capacitor 2410 470 nf/16v | I replaced it and it worked perfectly | marcelokvaco |
| PHILIPS |
14PT110A
78R |
Does not turn on (does not oscillate) only in standby and normal +b lines. | Change eeprom memory. | jayjunior | |
| PHILIPS |
21PT9467C78
A4 |
Volume goes down to zero and doesn't go up but | Microprocessor tda 9376 | Replace and mediation | eletronica pai e filhos escada |
| PHILIPS |
DVP 3320K
|
Turns off after 3min | Ci tny176pn pos u1 | VICCARI | |
| PHILIPS |
29PT4636/78
L01.1L AC 2K3 |
This TV sometimes turns on 3 attempts or more when it turns on it has a serrated sound | Bc337 bc 327 c2455 c2405 worked normally | antonio dos santos lima | |
| PHILIPS |
21PT5435
0000 |
TV with +b ok but it doesn't oscillate, it doesn't turn on. | Regulator 7493 of 3.3v altered p/ 5.5 = 78l33 | Replaced it and everything was ok!!! good luck! | Jhone Eletronica |
| PHILIPS |
21PT9467C/78
SK4.1L |
Vertical deflection only halfway down. Half up, some colored streaks appear | Vertical ci power supply ok (+15v and -15v), vdra signal sawtooth ok, vdrb deformed. | After several tests, vertical CI replace, cold test of several components, defect was d351 ba158. Tsound is no point in measuring, you have to replace directly. test c352 100μF/50v which may be altered. | Renato Pareta |
| PHILIPS |
20 MT 21 31/78
|
It doesn't turn on and the stand-by LED is stuck, it oscillates when you press power on the remote control. | ,I checked the good condition of the soldering on the pins of the large integrated ci- 7200,even though it was in good condition, I carried out a careful re-soldering,this device is so difficult to maintain,it started to work perfectly, ok !!!!!!-- | ELIZEU RAMOS | |
| PHILIPS |
MONITOR 150S6FS
|
Functions frozen, dark screen | Unlock by pressing and holding the ok key, after message enter my color change until image appears | warley cesar | |
| PHILIPS |
20GL1344
|
Does not turn on, all primary voltages are low. | Audio amplifier. | FERNANDO S | |
| PHILIPS |
42PFL5332
LC7.1A.LA |
The device has a blue LED on, as if it were on, without an image, it does not respond to commands | Right and left inverter capacitors swollen 470mf/35v mosfet burnt fdd8447l | I replaced the capacitors and mosfet and it was ok, don't replace boards without trying to fix them, your profit will be higher | Ricardo |
| PHILIPS |
21PT9467
|
AV input no image only audio | Dz454 shorted | paial.eletros |