Philips Repair Tips

Search: philips
Results: 14206

Make	Model	Symptom	Problem	Solution	By
PHILIPS	14PT314A L9SS	Fails, runs away color	When you touch your hand to the crystal(palm) color comes out	Ground the crystal body (the shielding}	jasvan souza
PHILIPS	21PT8467	With dark screen 8sg turns off	Capacitor g2		carlinhos100
PHILIPS	20GX1650 ANUBS	Black bar on the right side and heats the horizontal	Polyester capacitor c 2444 open or cold sound	Replace the c 2444	cetrel eletronica
PHILIPS	20GL1015 GR1VA, RO3, L1	Does not turn on, LED dimly lit	+16v with just 5v, and memory pin 8 with 2.5v	220μF electrolytic +16v slightly altered, replace	jasvan souzaq
PHILIPS	14PT314A L9	Blinking led	3400 broken		carlinhos100
PHILIPS	14PT3331	Turning off only in av	After testing some components I didn't find anything but I already got this defect when turning off it was the CI that does everything	As this time I didn't have the CI that does everything, I disconnected pin 36 xrai and it was ok	Evandro/sousa.Astel Eletronica
PHILIPS	21PT9467C/78 SK4.1L	When it turns on, it just makes a noise from the relay and tsound is no image or sound	Flyback raised the voltage in the vertical and burned the d303, d304, c315, c316, ic351 and in the power supply circuit of the rgb r318 and d305	After changing the flyback xt bsc29-3807d I noticed that after a few hours on the image tsound was a windshield effect in the center of the image (pulled to one side) I put a shim on the ferrite and it was normal.	Helio(Eletrosonic)
PHILIPS	21PT6456/78	\|no color	Color system does not appear in the menu	Enter service mode by typing 062596 on the control + menu > options > op > enter 000.	Evandro Estrela
PHILIPS	14PT218A 78R	Burning d6405	Change vertical output (tda9302)		jayjunior
PHILIPS	20PT3336/78	After about 5 minutes on, reduce the width on both sides.	Capacitor c2408 (apparently good) 560n defective		Carlos Maia
PHILIPS	20GL1049	TV works - has audio without image	Tube socket	Replace	EMERSON RIBEIRO
PHILIPS	107S6	Turns on and off without stopping. contrast messages appearing.	Full of poor contact, including on the tube plate and defective microswitches.	Re-solder the board and replace the four keys.	bimladem
PHILIPS	29PT9457 L07.1L	Dead power supply	No 140 volts and secondary power supply does not work	Replace coupler photo	jedvaldo
PHILIPS	14PT314A	Image shifted to the right black band on the left side without OSD	R-3404	Replace 12k r-3404	ladmyr eletronica universal
PHILIPS	14PT3131 L03.1L	Pulsating power supply voltage dropping	Ci.7520 - photo coupler		REDELVIM
PHILIPS	20PT4331 78R	Does not work-dead.low voltages.	ET8011 photocoupler. in the cold test it was fine. but when changing it the TV worked.	Replace. I put the pc 817.	Rondinele_Serviço Especializado Semp Toshiba_Campo Redondo/RN.
PHILIPS	21PT5433 78R	It's peppery	T 7466(smd),t 7463(bc 546) e r3445(1r).	Replace these components.	Rondinele Serviço Especializado Semp Toshiba Campo Redondo-RN
PHILIPS	29PT5642/78	Turns on and then turns off, when the screen increases, it shows a horizontal line, below the middle of the screen.	The defect was the 56k r3606, through which the 5v from the micro passes		antonio dos santos
PHILIPS	29PT458A	Turns off by itself	Bad contact on q7450 horizontal output transistor		Eletronica lelo
PHILIPS	29PT4635 L01.1L	The TV turned on normally, after about 5 seconds, it turned off, either by pressing the channel or turning it on using the control, it turned on normally, but turned off again.	Causes a defective tube, so you tap lightly, with the back of the screwdriver, the plastic part, lightly tap the barrel of the tube, so you can see that the internal oxidation of the tube is burning, this solution may last a few days, But the good thing is to change everything.	Replace everything was fine.	ELETRÔNICA MOISÉS NH