Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
29PT4631
|
Jagged image | After changing the vertical IC and capacitors, the image came with aliasing | After washing the plate a second time, the problem was solved. | ALVERNAZ |
PHILIPS |
32PFL3605D
|
It doesn't work, the LED doesn't even light up | Check q 501, r517,d501, ci oscillator, 12v power supply, d210. | Replace the mentioned components. If it doesn't work, see r 120, 10Ω, which feeds the 12v power supply oscillator. In this resistor tsound must be 14v. | arock |
PHILIPS |
HTS3510
|
Image chipping like a scratched record | D1 with escape | Replace without testing it is close to the engine bay | antonio nobrega patos pb |
PHILIPS |
20PT120
L7L |
The power LED would flash 5 times and it wouldn't turn on, the LED would stay on | Capacitors 2551-2448 os2 of 47 micro160volts os2 stavão without capacitance | Replace the 2 with 47micro 160 volts | jose avelar |
PHILIPS |
21PT9467C/78
|
Burning ic 601 | D610 shorted | To replace | rn eletronica fort-ce |
PHILIPS |
21PT9467C/78
|
Burning ic 601 | D610 shorted | To replace | |
PHILIPS |
29PT5645
|
Turns on the image and turns off | Cold solder rgb tube board | Resolder tube plate | |
PHILIPS |
20PT4331
|
Can't turn it on, holding the keyboard works quickly with the vertical closed and if you move the scrin it works normally | R 3491 amended | This resistor presents various symptoms depending on its replace | eletronicarotary |
PHILIPS |
FWM570/19
|
Turns on and then turns off | Transistor 7506 (bc847b) broken | Replace even if it is measuring good | jean alves |
PHILIPS |
20PT4331/78
|
On and off with retrace lines | Capacitor 2444 and 2446 with low capacitance | On the -12 v line | GIOVANNE AVELLAR GSAELETRONICA |
PHILIPS |
29PT4641/78
|
Solda fria no flyback | reinaldoramos | ||
PHILIPS |
32PFL3404
|
Lights flash, sometimes tsound is sound, power supply inverts low | Capacitor c1 220p had a crack | Capacitor c1 220p | elio |
PHILIPS |
21PT9467C
|
Turning on and off greenish retrace line without sound | D104 ph4148 leaking | Replace d104 | giba |
PHILIPS |
20PT3331
|
Stop - placing a 100w load lamp between the +b and ground, it lights up, however, weakly (the +b has approximately 30 volts) | Photo-coupler | ReplaceIt | |
PHILIPS |
29PT4640
|
Image warping with black band on the right side and noise near the flybac | C2455=47uf 25 | beto2828 | |
PHILIPS |
29PT554A/78
ATTON LIVE PARTS |
Works normally but with noise at the power supply | I hope for a solution | Thanks. | irineu jardelino ribeiro |
PHILIPS |
29PT4635
|
LED turns on and off normally, but does not fluctuate | Bu4508 | Short between emitter base. obs. does not interfere with the voltage of +b 140v. | ELTON CASTRO |
PHILIPS 14 |
14PT3336
L 03.6L CA |
Vertical closed, pulsing and turns off shortly after | Zener (33 v ) next to varicap position 6001 | Resolved, thank you to all forum participants. | geremias |
PHILIPS |
20PT122A
L7L |
When turning on the device, it showed the service mode activated, the LED responded to the remote control but did not turn off, suspending pin 8 of the memory turned it off and on normally. | Cause: faulty memory (24w04) | Replace it | |
PHILIPS |
21PT5433
21PT5433 |
180v power supply | R3442 | Replacement | Bento |