Philips Repair Tips

Search: philips
Results: 14231

Make	Model	Symptom	Problem	Solution	By
PHILIPS	29PT554A/78 ATTON LIVE PARTS	Works normally but with noise at the power supply	I hope for a solution	Thanks.	irineu jardelino ribeiro
PHILIPS	29PT4635	LED turns on and off normally, but does not fluctuate	Bu4508	Short between emitter base. obs. does not interfere with the voltage of +b 140v.	ELTON CASTRO
PHILIPS 14	14PT3336 L 03.6L CA	Vertical closed, pulsing and turns off shortly after	Zener (33 v ) next to varicap position 6001	Resolved, thank you to all forum participants.	geremias
PHILIPS	20PT122A L7L	When turning on the device, it showed the service mode activated, the LED responded to the remote control but did not turn off, suspending pin 8 of the memory turned it off and on normally.	Cause: faulty memory (24w04)	Replace it	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT5433 21PT5433	180v power supply	R3442	Replacement	Bento
PHILIPS	14PT4131	Turns on and then turns off... sometimes it turns on again but turns off again	Defective photocoupler... use and replace 2521 and 2528 (both 22u/50v)		Eletronica Staub
PHILIPS	14 PT 414	Turns on and off, when you keep the volume pressed it stays on, if you release it it turns off	See r 3440 amended		Master Eletronica
PHILIPS	PHILIPS 29PT8457/78	It gives a caption on the screen 00510l0453.4 err1951000 op000037128164250042008 (sdm)	The power went out and this caption looked like this when the TV was turned on		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	14GL1013 14GL1014 14GL1313 14GL1314 16GL1033 16GL1034 20GL1043 20GL2044 20GL1343 20GL1344_EE	70v low power supply +b with 37v replaced f422, f423, un4436	Doesn't even turn on the stand by	It was only resolved by changing the tmp47c834n-r167 processor, the final letters must be the original	ginaldo silva casa do radio picui para + dicas especificas na página principal do google casa do radio picui pb
PHILIPS	20GL1343 GR1-L1	Normal audio without image when opening the screen is retraced and very faded.	Video does not work. dead rgb	Capacitor c3410 in the vertical sector completely depleted. replace and run for the hug.	altair santos
PHILIPS	14PT314A	The TV turns on, the screen appears with retractions and then turns off.	The cause was broken resistor 3334=18k and capacitors 2409=47mf160v-2551=47mf 160v, I replaced them and the TV worked normally again.		ELETRÔNICA MELO BOA VIAGEM -CEARA
PHILIPS	42PF7320	Turning off with/shortly	Change the value of the 8094 resistor from 900k to 1m and adjust ve and vs, the voltages are at the top of the display		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT 5645	Cushion effect, not acting (eww) -(ewp) - (ewt) for adjustments.	Change the smd transistor (7484) bc 847. bc 547 can be used		Ademar Videira SC
PHILIPS	21PT6456	Doesn't work	Supply smd integrated circuit	Tea1506t	Eletronica lelo
PHILIPS	21PT6456	Everything normal but no audio	C2444 sec	Replace and run for the hug	digital system
PHILIPS	29PT558	Doesn't start	Capacitorc2450 47x160v l 5561 c2455 47x25v q337 q327	Replace -the	toninho da eletronica
PHILIPS	29PT5645/78 L04L AA	Image interference, only in rf	When changing channels, interference from another channel comes in	Replace in sam mode in tuner the parameters ifpll = 36, agc = 30 and cl = 10	leitemarcellus
PHILIPS	29PT4631	Warming up. 3343 on the rgb board...	Flay-back jf0501-8604, it was not original. Just click a good...		ELETRONICA INFOAÇU
PHILIPS	29PT4631	Does not turn on, LED off + b normal	Cap. c2561	Tip I got from a colleague on this forum	ELETRONICA INFOAÇU
PHILIPS	FWM417X/78	Dead	Defective 835 diode	Replace without measuring	BOMTEMPOMECATRONIC