Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
29PT752A/78R
A8 |
Dead | C-2618 (222 x 2kv) and fet-7680 (p16ne06). When changing c2618, when turning on the TV, when the image appeared it turned off as if it were a weak tube. | Swap c-2618 and fet-7680. obs. the fet is on the e61 board, east-west correction. | Tulio / Biguaçu SC |
PHILIPS |
21PT5433/78
LO3 |
Turns on and turns off for no apparent reason | The three bf423 of the tube plate touch directly | jose carlos fonseca | |
PHILIPS |
29 PT4631
|
Normal image, normal sound, with a four-finger dark bar on the left side of the screen from top to bottom and characters pulled to the left!!! | The horizontal exciter circuit of these devices is carried out by a pair of transistors 7461 (bc337-25) and 7463 (bc325-25) in complementary symmetry. Replace these two transistors even if they are measuring as good, as they always show a lack of gain. note the "dash" 25 that corresponds to the hfe of the transistors. As a precaution, also replace the capacitor c2405 between the collector and emitter of the npn 7461 (bc337-25). capacitor c2455 is also critical, due to capacitive reactance at high frequency, so replace it. also check the polarizations of the fet 7400. | Perse | |
PHILIPS |
29PT4631/78
|
TV works normally, then the image goes out and the screen goes completely black. | I replaced the two bc 7461(337) and 7462(327) and the two capacitors 2405(220mf 25v)2455(47mf 25v) change without testing. | ELETRÔNICA MELO BOA VIAGEM-CEARA | |
PHILIPS |
21PT9467C/78
|
Vertical closed, just a stripe at the top of the screen | Diodo byw36, resistor o,68rx2w e flyback bsc29-3807f | After changing it, the TV returned to normal. Note: the byw36 must replace both and observe the flyback if tsound is a high voltage leak | HIPERELETRONICA SERVICE (MARCELO MARAIAL) |
PHILIPS |
21PT5435/78
|
Not working, just whistles from the power supply | Q7421=but11ax. | Replace for original to avoid return and the +b is 120v and not 95v. | HIPERELETRONICA SERVICE (MARCELO MARAIAL) |
PHILIPS |
VARIOS
|
It does not work via the keyboard or the remote control, and messages appear on the screen | Press 89 and OSD on the remote control | Ademar / Videira sc | |
PHILIPS |
20PT-4331
|
Sound noise when in stand-bay | Place capacitor of 10k x 25 volts no pino 1 do ic 7902 (an 7523) to ground | Ademar / Videira sc | |
PHILIPS |
29PT6642/78
HC287229 |
Doesn't start | Not calling | JOSE DIVINO DE FREITAS | |
PHILIPS |
29GX1895
ANUBIS-VAA |
Out of tune and with error 4 | Varicap date line open | Trail recovery | paulo-maceio/al |
PHILIPS |
HTS3510/78
|
No audio comes out of the speakers | The amplifier's 33v is missing | Replace ci cq1565rt from primary power supply | SAMUEL LEITE |
PHILIPS LCD |
20PF4121
LC4.1E AB |
With sound, without image | Chap. ce106, ce107 both 1000uf on the power supply board (PSU). | Andrade Sequeira | |
PHILIPS |
32PF3320/10
LC4.5 LCD |
"f" appears in the image | The TV is in "factory mode" | To exit, press both "volume" "-" and "program" "-" keys simultaneously for 5 seconds. | Andrade Sequeira |
PHILIPS |
23MW9010/37
LC03U AA LCD |
I'm sound | Check ic7731 (an7522) | Andrade Sequeira | |
PHILIPS |
37PF7641D
BJ3.0E LCD |
Turns off after a second or two, green LED on, no sound or image. | Check 27mhz crystal. | Andrade Sequeira | |
PHILIPS |
29PT4635/78
|
No image | C2445 c47/Akhaf | Replace of the same | fco |
PHILIPS |
FW M35
|
Display does not light up | Sawtooth pwdn pulse is in sinusoid | D723 under tails. rusty trocheu | VITALTEC |
PHILIPS |
29PT9467
|
Inoperative everything off | C453,c621,c628,c632. | Replace them | eletroclaudio |
PHILIPS |
32PFL5604/78
S TCM3.2L LA |
The TV turns on with audio, but without backlight | C21 leak in the pfc circuit causing malfunction | leitemarcellus | |
PHILIPS |
20PT324A
|
LED lights up and flashing | Cap 47uf 160 v defective | Replaced and the TV worked perfectly | José nogueira |