☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS TODOS LINHA PT
Turns on, after a while it makes noise on the screen, Replace the (c-2472 of 150k) replace the (c-2473 of 100k) and the horizontal output transistor bu-4508/dx Ademar / Videira sc
PHILIPS 29PT 5645
L-4U 		Tsound is no +b in secondary school Check and replace ci tea 1620 of the power supply replace capacitor smd c 2532 and resistor r 2513 (2k2) Ademar / Videira sc
PHILIPS TODOS LINHA PT
Sreem adjustments in inches (14p 340volts) (20p 420volts) (21p 450volts) ( 25p 480volts) (29p 520volts) Ademar / Videira sc
PHILIPS 20PT 3331
Turns off after approximately 5 minutes Changing the q-7643 bc 546 can use the bc 547 Ademar / Videira sc
PHILIPS 20PT220
Sem osd Replace q-7682 Ademar / Videira sc
PHILIPS VARIOS
Image shifted to the right Replace( c-2448) ( c-2255) ( r-3242) ( r-3469) ( r-3490) ( d-6449) e (d-6468) Ademar / Videira sc
PHILIPS 20PT 3336
No image, just characters Swap r-3442 and r 3459 is close to the fly back Ademar / Videira sc
PHILIPS 3331
Reduced frame and power supply with 68 volts on the secondary Change the r 3526 without testing the value of 0.15r connected to the fet Ademar / Videira sc
PHILIPS 1340
Green screen with lines Touch zener diode (zd 359) 3.9 volts Ademar / Videira sc
PHILIPS CHASSIS L-04
L-04 		Turns off with error 11 Change coupler photo Ademar / Videira sc
PHILIPS TODA LINHA GR-1
Jagged image Replace r-3226 (18k) Ademar / Videira sc
PHILIPS 29PT4635
After 5 minutes the video disappears and tsound are only characters, also on the av. Replace ic 7200 o micro. Henderson(hndrsn)
PHILIPS 14PT3336/78
TV with broken board, restoration was done and the TV started working again, but kept turning off Solution: adjust the screen. and the TV was ok. Carlos
PHILIPS 23PFL5522D/12
LC72ELB 		Does not turn on, LED of, power supply vibrates Na power supply d205 (sb360 ,3amp 60v) Replace c24 (331k/3kv) J.CUNHA
PHILIPS FWM57
Damaged by lightning (dead) After a lightning strike, he was dead, with the display completely turned off. On the power supply board I found inductor 5929 open, whose value indication in the diagram is 1m. as inductor 5931 also has the same value, I measured its resistance and found 12Ω. So I added three identical inductors (from a piece of scrap) which together gave almost this much, I replaced them and the device was perfect. In the open inductor I could notice that the wire was extremely thin and despite it being in series with the 200 ma fuse 9902, it will certainly always open before the fuse, in case of overload. littlecarlos
PHILIPS 29PT4635/78
Dead power supply does not turn on standby LED does not have +b 140v +b12v Capacitor 2521 22mf 50v Replace with new brancobilli
PHILIPS 20PT4331
L03.1L 		It turned off after 5 seconds. error 11 in service mode Resistor 3443 (3r9) resistor 3444 (4r7), resistor 3403 (340r) overheated and altered Replace for another of the same respective value djeferson hoed
PHILIPS 14PT316
Does not turn on LED does not light up It had 170 volts in the primary power supply but c.i. The power supply oscillator had no power supply, I found the 6540 diode (bav21) shorted, I replaced it and still tsound was no voltage, I replaced the c.i 7520 and the TV started working again JOSÉ GUSMÃO
PHILIPS 14PT3331
L03.1LAA 		+b oscillating. TV doesn't turn on R3524 smd em curto paulorusso
PHILIPS 21PT6456
L03.1 		Fountain chirping does not turn on Capacitor 2424 next to the flyback Ozias