Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
21PT5433
|
It turned on then turned off in approximately 2 minutes | C2463 and c2465 | In my case, that's all it was. Thanks guys, let's send you a tip lol | Rafael Dores |
| PHILIPS |
29GX1899
|
Turns off as soon as it comes out of stand-by | Check the voltage of the ic 7800 and resolder it and check the diode 6571 in4141 | Replace the diode 6571 in4141 | DAVI PEIXE-BOI |
| PHILIPS |
42PFL3604
|
Doesn't turn on, everything is off | C806 4u7/450v exhausted in the primary causes the burning of other components in the primary of this 3v3 power supply. | C806 4u7/450v depleted, r801 2r7 and r825 2r7Ω open and u801 = fsq510 shorted | BRUSKE |
| PHILIPS |
29PT554
|
Apparently normal power supply, but it doesn't turn on, triggers protection | C2551 47 x 160v seco. | ||
| PHILIPS |
20PT3331
|
Works for a few hours and appears retrace lines and turns off | Defective scrim potentiometer | Flyback replacement | eletronica reis |
| PHILIPS |
20PT3331
|
Turns off after some time | Capacitor 2303 on the tube plate | Replace without measuring | eletronica reis |
| PHILIPS |
20GL-14GL
L1-RO3-GR1VA |
No secondary power supplys. | R3319 of 100k open | Replace | jasvan souza |
| PHILIPS |
20PT3331
|
Vertical dated,horizontal pressing. | 7491 with leak | valnireicholz | |
| PHILIPS |
20PT3331
|
Doesn't start | R 3445 1r sai do pino 8 do fly back | HP ELETRONICA | |
| PHILIPS |
14GL1011
|
No sync | C248 | C248 (22u/50v) | Eletrônica Staub |
| PHILIPS |
21PT
LOL3 1L |
Sem vertical | No -12v on tr collector 7465 | R3445 of 1r open, on pin 8 of the fly. | jasvan souza |
| PHILIPS |
FWD798/55
|
Totally inoperative (display off) | Transistor q911(2sb772) shorted on the power supply board | Replace the same. | jheliocavalcanti |
| PHILIPS |
29PT5642
|
Reduced frame on the sides, approximately 20cm on each side, missing width | Q7406 open 2sc3207 | Replace, plz | beto2828 |
| PHILIPS |
20PT3331
|
It didn't work it just chirped | Trans. hot. shorted | I replaced caps47/160 and 2200/16 medi+b ok I put the hor and glory to God | RLSC |
| PHILIPS |
14PT3131
|
With image, without sound | C2444, 470/16v, next to the fly beck | jps eletr,campo,grande | |
| PHILIPS |
21 PT8467/78
|
Vertical, closing 2 to 3 centimeters at the top of the tube | Capacitor-2465 of 10x160v, if it persists, trace the capacitor-2460 of 82nkx250 | ELETRONICA CAVALCANTE MARTINOPOLE-CE | |
| PHILIPS |
25GX1888
VA A |
Does not oscillate | Open horizontal driver | Replace driver horizontal | luciano |
| PHILIPS |
21PT9467
|
When turned on, it shines and closes, when it firms up it leaves a wide, very luminous band at the top | Diode 304 r310 which supplies the vertical with negative voltage and diode 305 and r318 supply voltage 180v. | Went to replace it worked. | genivaldo itumbiara GO |
| PHILIPS |
14PT112A
L7L |
The device works intermittently (sometimes it turns off by itself) | Cold solder on the ic pins - mc44603a (7520 - power supply oscillator) | Resolder all pins | adhemar caetano da silva (tecmil eletronica) |
| PHILIPS |
20PT122A/78R
LZ |
TV on standby, when it turns on the LED blinks about 5 times and turns off | Welded chopper pin that goes to ground with cold solder on the secondary | Paim |