Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
TODOS LINHA PT
|
Pt televisions, when the transistors (bc-327 and bc-337) are replaced and a white streak is noticed on the screen on the left side | Add 01 ceramic capacitor of 10k x 50 volts between the emitter and collector of the bc-337 | Ademar / Videira sc | |
| PHILIPS |
14GL 1010
|
Running vertical | Replace capacitor (c 930 de 100pf) | Ademar / Videira sc | |
| PHILIPS |
29PT 554
|
Vertical thick lines | Switch (r-3410 and r-3411) are connected in parallel with the deflector | Ademar / Videira sc | |
| PHILIPS |
20PT 222
|
Closing the image from left to right. | Change diodes d6461 / d-6464 (1n4148) change c-2469 (390pf) c-2462 (4k7) the capacitors are 2kv | Ademar / Videira sc | |
| PHILIPS |
29PT 552
|
Sem +b not secondary | Check the capacitor (c-2550) which is connected in parallel with the d-6550 | Ademar / Videira sc | |
| PHILIPS |
TODOS LINHA PT
|
Turns on, after a while it makes noise on the screen, | Replace the (c-2472 of 150k) replace the (c-2473 of 100k) and the horizontal output transistor bu-4508/dx | Ademar / Videira sc | |
| PHILIPS |
29PT 5645
L-4U |
Tsound is no +b in secondary school | Check and replace ci tea 1620 of the power supply replace capacitor smd c 2532 and resistor r 2513 (2k2) | Ademar / Videira sc | |
| PHILIPS |
TODOS LINHA PT
|
Sreem adjustments in inches | (14p 340volts) (20p 420volts) (21p 450volts) ( 25p 480volts) (29p 520volts) | Ademar / Videira sc | |
| PHILIPS |
20PT 3331
|
Turns off after approximately 5 minutes | Changing the q-7643 bc 546 can use the bc 547 | Ademar / Videira sc | |
| PHILIPS |
20PT220
|
Sem osd | Replace q-7682 | Ademar / Videira sc | |
| PHILIPS |
VARIOS
|
Image shifted to the right | Replace( c-2448) ( c-2255) ( r-3242) ( r-3469) ( r-3490) ( d-6449) e (d-6468) | Ademar / Videira sc | |
| PHILIPS |
20PT 3336
|
No image, just characters | Swap r-3442 and r 3459 is close to the fly back | Ademar / Videira sc | |
| PHILIPS |
3331
|
Reduced frame and power supply with 68 volts on the secondary | Change the r 3526 without testing the value of 0.15r connected to the fet | Ademar / Videira sc | |
| PHILIPS |
1340
|
Green screen with lines | Touch zener diode (zd 359) 3.9 volts | Ademar / Videira sc | |
| PHILIPS |
CHASSIS L-04
L-04 |
Turns off with error 11 | Change coupler photo | Ademar / Videira sc | |
| PHILIPS |
TODA LINHA GR-1
|
Jagged image | Replace r-3226 (18k) | Ademar / Videira sc | |
| PHILIPS |
29PT4635
|
After 5 minutes the video disappears and tsound are only characters, also on the av. | Replace ic 7200 o micro. | Henderson(hndrsn) | |
| PHILIPS |
14PT3336/78
|
TV with broken board, restoration was done and the TV started working again, but kept turning off | Solution: adjust the screen. and the TV was ok. | Carlos | |
| PHILIPS |
23PFL5522D/12
LC72ELB |
Does not turn on, LED of, power supply vibrates | Na power supply d205 (sb360 ,3amp 60v) | Replace c24 (331k/3kv) | J.CUNHA |
| PHILIPS |
FWM57
|
Damaged by lightning (dead) | After a lightning strike, he was dead, with the display completely turned off. On the power supply board I found inductor 5929 open, whose value indication in the diagram is 1m. as inductor 5931 also has the same value, I measured its resistance and found 12Ω. So I added three identical inductors (from a piece of scrap) which together gave almost this much, I replaced them and the device was perfect. In the open inductor I could notice that the wire was extremely thin and despite it being in series with the 200 ma fuse 9902, it will certainly always open before the fuse, in case of overload. | littlecarlos |