Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
14PT3132/78R
|
Has audio characters and a dark screen | R3442 open abl line | samuel leite | |
PHILIPS |
HPS-2991FS
|
TV burned out the bu 2520dx so far so good, so I bought another one I put it in its place but it didn't work it just oscillated but didn't produce high voltage, checking all the voltages which were ok after so much inspection I decided to put another one from an old board a bu 1508 then the TV worked | Moral of the story, the bu I bought looked good but was bad internally, so sound's a tip guys, be careful with your bu lol | ||
PHILIPS |
TV PHILIPS GX 1899/78
|
No weapon power supply | Replace c 2420 c 2411 and c 2418 | JCARLOSMART | |
PHILIPS |
29PT558A
|
Without sound, but with image. | Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails. | Bridge. | lou |
PHILIPS |
29PT658
|
No sound, but normal image. | Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails. | Make a bridge. | lou |
PHILIPS |
29PT554A
|
Horizontal wind blower | Resistor r3448 of 8k2 open. | Ademir solânea pb | |
TV PHILIPS |
14PT3131
|
Turns on the image appears but turns off in + or - 05 seconds | Capacitor 2503 in the power supply primary | Replace capacitor 2503, in the power supply primary. This capacitor was too small for its function. put a bigger one. | caio |
TV PHILIPS |
14PT3131
|
Turning off in 5 seconds | Replace capacitor 2503, in the power supply primary. This capacitor was too small for its function. put a bigger one. | caio | |
PHILIPS |
FWM416X/78
|
Like fanhoso | Replace without measuring q721 | fabiusmax | |
PHILIPS |
32PFL3403/78
|
Does not turn on, only the standby LED is on. | Eeprom memory (7l23) corrupted. | leitemarcellus | |
PHILIPS |
14GL1016
|
Philips tv 14gl1016 defect with normal sound on all channels + nothing appears. | C2410 close to the top – vertical | ONLY replacing the c2410 | ginaldo silva casa do radio picui pb |
PHILIPS |
29PD860A/78R
A10 |
When turned on, it goes into protection mode, activating transistor 7440 (prot-up), resistor 3437 open (22kohms) | Replace resistor 3437 and check the others that are in series with it. | leitemarcellus | |
PHILIPS |
29PT9467C
0000 |
TV without plot, just retrace | Diode 402 abl with leakage | Replace and resolder the other components of the stage and everything went well-good luck!!! | Jhone eletronica |
PHILIPS |
14PT113/78R
|
Power supply does not adjust and the image oscillates | R3528 de 0r33 3w | Replace | EletroClaudio Aguas Belas |
PHILIPS |
40PFL5615D/78
Q552.1L LA |
Does not turn on, standby LED does not light, power supply defect | 5.6v standby power supply schottky diodes short circuited. | Replace the diodes with an equivalent (2.0a 60v) that is double internally. | leitemarcellus |
PHILIPS |
20GL1045
|
Turns on, then turns off, with LED flashing | 6365 diode (6v2), measures good... change | Eletronica Staub | |
PHILIPS |
29PT4631
|
Does not turn on standby led off and b+ zero voltage @@@ | Photocoupler can put the photo 817 | ELETRONICA ARNI/L.LEAL-SC | |
PHILIPS |
14GL1019/78
|
With audio and without image | When I enlarged the screen a little I noticed the drizzle and the OSD, I inserted another blank EEPROM. | Changing the eeprom, note: this model just inserts a blank eeprom and the micro programs the data. | HIPERELETRONICA SERVICE (MARCELO MARAIAL-PE) |
PHILIPS |
HNS7150T
|
Monitor turns on and off constantly, button panel does not respond | Sw4 and sw5 of the button panel board | Replace for new ones | gilbertobock |
PHILIPS |
21PT5433/78R
|
When you turn on the sound it is low, after 3 minutes it returns to normal | C=2444 of 470mf | Replace and analyze components on the same line | ELETRONICA MEDEIROS |