Samsung Repair Tips
Search: samsung
Results: 3801
Results: 3801
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
CI5322XT
|
Dead - psu overworking & ht excessive at 250v | Correct ht 125v when c852 470µ 16v replaced but r826 1r o/c & loptr 2sd1650 s/c also | ||
| SAMSUNG |
CI5322T
|
St/by led comes on briefly at sw on then dead | C817 100µ low cap | ||
| SAMSUNG |
CI5322T
|
No sound/pic - raster present when a1 advanced | 5v supply low from ic803 5v reg - reg s/c | ||
| SAMSUNG |
CI5322T
|
If replacing width coil gives tuning/if fault chec | 21" 32449-412-650 14" 32449-412-603 | ||
| SAMSUNG |
CI5322T
|
Dead | R801 5r6 7w o/c; c816 2200pf 1kv cracked & leaky | ||
| SAMSUNG |
CI5322
|
Field collapse | R412 o/c & check d401 erb4304 also c307 100µ 50v | ||
| SAMSUNG |
CI5322
|
Field collapse | R412 oc also replace d401 and c307 ( 100uf ) | ||
| SAMSUNG |
CI5312W
|
St/by only - chopper tfmr squeals when not in st/by | C807 47µ 25v & c813 1µ 50v hi esr | ||
| SAMSUNG |
CI5312
|
Dead, sqeals when sw out of st/by | C807 47µ 25v & c813 1µ 50v hi esr | ||
| SAMSUNG |
CI517ZF
|
Low brightness | C519 10n 2kv a1 decoupler on crt base | ||
| SAMSUNG |
CI517Z
|
Stuck in av mode | If strip perm muted as eq101 2sc815 tr leaky - used 2sc1815 in lieu | ||
| SAMSUNG |
CI517Z
|
Blank screen , if av selected , scart signals ok | Eq101 2sc815 sc | ||
| SAMSUNG |
CI517
|
Int col - high ht | Ta7698ap chip overheats due to hi ht 160v instead of 125v str30125 power chip faulty | ||
| SAMSUNG |
CI515ZA
|
Int blowing fuse. | Replace 800ma with a 1at anti-surge type. | ||
| SAMSUNG |
CI514Z
|
Dead relay clicking | C411 100pf 2kv sc | ||
| SAMSUNG |
CI5102Z
|
No signals , tune volts vary but no stations | Check rq04 , 05 , dz824 33v 05 10k 0.25w | ||
| SAMSUNG |
CI5079Z
|
Psu kit when blow up/loptr goes s/c | Both his0169c, smr40200c;r2kn 0403-000691; ksd5072yd 0502-000295;c852 2301-000111; 2n2 800v cap ;2303-000163;coil aa27-90001g | ||
| SAMSUNG |
CI5079Z
|
Dead - f801 3.15a fuse o/c | Smr40200 s/c pins 3-4, dz801 r2kn s/c, hc801 his0169b also reqs replacement | ||
| SAMSUNG |
CI5079Z
|
Dead - chopper tr s/c, avalanche diode s/c | Caused by his0169 hybrid device - replace with his0169c modified type to prevent ht rising in st/by - also change c852 1n8 ceramic cap with a polyester type you can purchase 10 of them from ard for 25p + vat! the order code is 160-00458. check ht in st/by - should be 140v but could be much higher if any of the former are faulty | ||
| SAMSUNG |
CI5079Z
|
Dead | Replace ic801, l803, zd801 |