Search: samsung
Results: 3801
Make Model Symptom Problem Solution By
SAMSUNG CI5052X
Int low brightness A1 pot on loptx & c907 10nf 2kv
SAMSUNG CI5052X
High ht should be 125v C852 470µ 16v
SAMSUNG CI5052AT
Height reduces with bounce Ic402 12v reg mc7812
SAMSUNG CI5052AT
Frame collapse Check d412 and r412
SAMSUNG CI5052AT
Field lowers when warm then bounces Ic402 mc7812
SAMSUNG CI5052 P68
"store" & "channel" in flash on screen 1n4148 diodes in key strobe lines to micro ric01 leaky
SAMSUNG CI5052
No sigs & partial field collapse B+ (12v) to tuner low at 1.4v. r419 10r safety res o/c (not shown in manual)
SAMSUNG CI5038Z
Tripping with ht low at 102v instead of 125v Smr earthing was suspect on heatsink (new type device recently fitted) i psu
SAMSUNG CI5030AN
Slightly off tune at sw on gradually improving C401
SAMSUNG CI5030AN
No pic for up to an hour No line lock - adj h sync preset
SAMSUNG CI5030
No sound. X601 xtal ( stereo sound
SAMSUNG CI5027
Dead 4 x bridge rects, str50103, d801 r2ky caused by faulty scan coils
SAMSUNG CI501FT5X
Bright white raster at sw on then trips out & repeats Zd201 5v1 zener faulty - line pulse clamp pin 42 tda8842 jungle chip
SAMSUNG CI5013T P58SC
Wont start or trips , with no sby light Checkr 811 100k
SAMSUNG CI5013T P58SC
Stuck in stby no 12v or 16.5v Micro 10mhz xtal us
SAMSUNG CI5013T P58SC
Int no startup - stuck in standby. 100uf 25v & 100uf 16v next to tda4601 psu ic heat sink.
SAMSUNG CI5013T P58S
No sound & sweep tuning won't stop R709 27k which feeds ident signal to pin 29 of micro ric01 o/c
SAMSUNG CI5013T P58S
Dead - q801 chopper tr reads s/c Q801 ok as c816 2n2 1kv in parallel with it was s/c, r801 5r6 7w o/c
SAMSUNG CI5013T P58S
Chans will tune but not store Rr53 3k3 pull up res to eeprom chip hi res
SAMSUNG CI5013T P58
Picture blanks in sound of text on pic returns af 27mhz xtal on text pcb