Samsung Repair Tips

Search: samsung
Results: 3801

Make	Model	Symptom	Problem
SAMSUNG	CI338Z	Chan display shows "88" but chan change ok	Check tr805 & dz809 ( 5v supply pin 24 ic4 low)
SAMSUNG	CI338XA	Int blowing fuse.	Replace 800ma with a 1at anti-surge type.
SAMSUNG	CI338X P50	Tuning drift - sudden & erratic	Cracks around connector sn01
SAMSUNG	CI338X P50	Tuning drift	Crack around connector sno1 from remote panel
SAMSUNG	CI338GA	Int blowing fuse.	Replace 800ma with a 1at anti-surge type.
SAMSUNG	CI338GA	Dist sound	R614 o/c; r601 2k7 hi res
SAMSUNG	CI338F	No col when warm	Zd501 leaky
SAMSUNG	CI338 P50	Very erratic and sudden tuning drift affected by mo	Check for crack arouind pin 1 of screened connector sn01
SAMSUNG	CI338	Int sound	Dry joints ic101 la7520 if chip
SAMSUNG	CI338	Dead.	R413 (1k), bu508.
SAMSUNG	CI3373Z SCT11B/D	Service mode access	Stby/p.std/help/sleep/power on. controls vol +/- channel +/- exit with status,{all on r/c}
SAMSUNG	CI3373Z	Field coll & poss no sound aft storm	Micro faulty (£40)
SAMSUNG	CI3373Z	Dead	3.15a fuse o/c; ic801 smr40200 s/c; dz801 r2kn s/c; l801 39mh damaged also hc801 his0169b hybrid ic
SAMSUNG	CI3373 SCT13B	Dead - led flashes every 2 seconds	Dry joint coll loptr - not obvious to see
SAMSUNG	CI3373	Faint pic	Set to 'mild' on handset - reset to normal
SAMSUNG	CI3373	Dead with fuse blown	Check zd8011 for s/c
SAMSUNG	CI3352XT P68C	Dead with loptr s/c	Check 125v ht line before replacing loptr q402 2sd1651 - should be 125v. if higher c852 470µ 16v on psu pri is usually the cause
SAMSUNG	CI3352AT P68	Slow to change chan, go into txt & analogue functs	Tx01 27mhz xtal
SAMSUNG	CI3352 P68	Dead - ic801 sdh209b faulty	When replaced, 125v ht was 170v due to c852 470µ 16v faulty
SAMSUNG	CI3351X	Will not tune in.	Dz824 ( 33v ) leaky , r822 ( 15k , 2w ) o/c.