Sanyo Repair Tips

Search: sanyo
Results: 852

Make	Model	Symptom	Problem	Solution	By
SANYO	CE28SW4 PT90	TV doesn't turn on, nor does the LED light up	Smd party	Replace o cp 12 680pf smd	Jorge Correia
SANYO	VARIOS-CHASSIS A3 A3	Dead, no LED lights up	Start by measuring the mat transistor. If it is shorted, do not turn on the TV without first measuring the r555 on output B1 (130v) on the power supply. If it is dead or altered, the new transistor will burn out as soon as you turn on the TV.		electronico
SANYO	CTP-3791P	Blue stripe on the left	Dakha
SANYO	CE28SW02 PT90	There is no OSD, a well-framed normal image	I.c. stv9306 vertical amplifier		telegaia
SANYO	CTP 3791	Doesn't start	Resistor r601 (120k), open		Sérgio
SANYO	29LH43B 29LH43B	TV turns on and activates the security system, turns off, never opens image	TV turned off and I replaced the vertical ci		nilton melo e siva
SANYO	29LH43B	Sem cor em pal-m	Ci la7680
SANYO	C20DN4 VESTEL - CONTINENTE	Horizontal stroke	R410
SANYO	CTP-3771	Power supply does not start	R520 and/or r521 changed
SANYO	CE28SN4	Tries to start and turns off	Verificar r603 0.47Ω e ic vertical
SANYO	6781	Glossy stripe 3 centimeters wide in the center of the screen and then upwards a fully stretched image	C451 (470mfx16v) -c455 (1mfx50v)
SANYO	C20BG2TXN - CHASSI PT11	Blocking video and sound momentarily. I even worked for hours ok	Tda8361
SANYO	C25EG35N CHASSIS EB2A	It starts and works well for about five seconds, after which it goes to stand-by.	R394 (390k) open.
SANYO	C20BG2TXN CHASSIS PT11	Power supply does not start.	Change the 3.9m resistance that goes from the + of the filtering capacitor to pin 11 of the tda16846 ic.
SANYO	CE14AT2 CHASSIS 2112 / EC7A	No image - with a blue screen as if there was no antenna signal.	Tuning circuit ok, resistance r206 (220Ω smd) open.
SANYO	CHASSI EC-1	Image as if it were out of tune, varying as if the tuning voltage was unstable.	Q201 leaking
SANYO	C20DN4AVN CHASSI PT11	Does not start, relatively normal voltages	220uf c31 with little capacity
SANYO	CEP1497E	Tries to start but immediately shuts down by turning off the protection turns on, but without vertical amplitude	Ver c706=470mf/16v
SANYO	CE21AT1 CH. EC-A4	Tries to start by switching to standby.	I had the 3.3m r718 open.
SANYO	CE28FT2 CHASSIS 2110-EB-5B	LED lights up but does not start. Voltages at the power supply are normal.	A damaged bc848. this bc is mounted on a board that is powered by the reset line. when turning on the TV, the reset voltage was 0.16v, instead of 5v.