Sanyo Repair Tips
Search: sanyo
Results: 853
Results: 853
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SANYO |
ED1 CBP2572
|
Field collapse at top of screen | C460/461 1000µ 25v, c408 4µ7 50v, ic401 tda8172 & r464 1r 1w | ||
| SANYO |
ED-1
|
Trips twice then off | Tda1521 audio o/p chip ic390 leaky | ||
| SANYO |
ED-1
|
Off with faint st/by led | Q304 2sc536 error amp in psu u/s also check 5v reg | ||
| SANYO |
ED-1
|
No pic sound ok | Vcu2136 ic501 on digital board | ||
| SANYO |
ED1
|
Trips 4 times then dead | R314 10r in psu - lt supply once set has fired up | ||
| SANYO |
ED1
|
Pic blanked out at sw on except for 2" strip at bottom | Dry joints q453 in st/by sw cct | ||
| SANYO |
ED1
|
No pic - just bright glow at top of screen | Dpu2553 ic508 on digital pcb pt no 409 211 87 01 | ||
| SANYO |
ED1
|
Mosaic - like pic | Ic502 pvpu2204 (pal vid proc unit) | ||
| SANYO |
ED0 CHASSIS
|
No sound | Ic1680 tda7253 & icp853 o/c | ||
| SANYO |
ED0 CHASSIS
|
Bright raster - sound ok | R534 22r safety res & check ic500 tea5101a rgb o/p chip | ||
| SANYO |
ED0 CBP2876A
|
Dead - loptr q650 2sd1556 s/c | C605 2µ2 line dr coupler leaky was cause | ||
| SANYO |
ED0 CBP2576/2876
|
No pic, no sound when entering tuning mode (just snow) | Enter service mode and enter correct configuration code 02014 | ||
| SANYO |
ED0 / EB1
|
To enter service mode | Press & release diamond memory key on front ("factory" shows on screen), press index/menu on hset within 5 secs; 1st tab on serv menu highlighted to allow entry of config code (02014) from handset. pressing the r/c menu key again changes osd to next setting, then alter with "vol+" & "vol-". to alter next parameter press sound button (under vol+ button) to highlight next tab. recommended values:- ho=02140; so=01012; s1=00081; ao=00186; yo=00050; po=15861; zo=01369; p1=01665; z1=00087; sp=00009 | ||
| SANYO |
ED0
|
To enter service mode | Press/release "mem" on front panel & "menu" on r/c within 5 secs | ||
| SANYO |
ED0
|
Service mode | To enter service mode press memory on tv and within 5 sec press menu on remote control | ||
| SANYO |
ED0
|
No pic due to field collapse | Tda8170 field chip blasted, r715 n25 cp o/c due to c703 100µ 50v | ||
| SANYO |
EC3A25 CB5956
|
Dead with led flashing dimly | Ht at 57v, dry joint on black wire to side of chopper trfmr | ||
| SANYO |
EC3 CB5156
|
When switched on from stby, the set immediately reverts back to stby | In protection mode (pin 31 ic701 below 5v) due to r327 390k o/c | ||
| SANYO |
EC3 CB5156
|
Drifts off tune | Replace c105 1uf 50v near tuner | ||
| SANYO |
EC3 CB5153
|
Dead | Q432 2sd1651 s/c |