Sanyo Repair Tips

Search: sanyo
Results: 852

Make	Model	Symptom	Problem
SANYO	CTP6132	Dead	F301 800ma o/c; q304 chopper tr s/c;c308 100µ was the cause
SANYO	CTP6130 80P	Dead.	Ra02 (330K)
SANYO	CTP6114	Set trips or will not start	Check 5v reset to microcontroller t319 primary o/c increase r319 to ( 680r )
SANYO	CTP6102	Frame - scan creeps up as set warms up.	Q422 leaky.
SANYO	CTP5103	Frame rolling.	D201 leaky.
SANYO	CTP5103	Frame reduced - 3" at centre.	C451 ( 330u f , 10v ) leaky.
SANYO	CTP5103	East west - bowing out.	Change c451 ( 330u f ) & try c455 ( 330nf ) & c456 ( 180nf )
SANYO	CTP5101	No picture - sound ok.	R617 ( 330k ) o/c.
SANYO	CTP3131	Severe raster distortion , fast rolling	Mains smoothing o.c. 100mfd 400v
SANYO	CTP3131	Blank raster with flyback lines	Check r464 ( 100Ω ) 85v supply to rgb o.p.
SANYO	CTP3106 80P	No colour.	C202 , c204.
SANYO	CTP3106 80P	Dead.	No 300v at c308 , check l1001 , sw1001 , r301 , l302.
SANYO	CTP3106 80P	Dead - 800ma fuse blown.	Check q304 , c315 , ( 1500pf ) , q301/2/3 , d305/7.
SANYO	CTP3106 80P	Dead - 2a fuse blown.	Check c1001 ( 100u f ) , d301 , c308 ( 100u f )
SANYO	CTP3105 79P	Sync - no sync.	R403 ( 1k ) o/c , if not replace ic401 ( la1460 )
SANYO	CTP3101	No results.	Q432 ( bc107 )
SANYO	CTP3101	No luminance.	Q342 checks ok out of cct.
SANYO	CTP3101	No lum	Q342 in blanking cct
SANYO	CTP132	Top foldover	C44 4µ7; c447 10µ
SANYO	CTP130/1/2	Dead - blown or blowing line transistor.	Dry joint on heatsink support tag.