Sanyo Repair Tips
Search: sanyo
Results: 852
Results: 852
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SANYO |
CBP2576A ED0 CHASSIS
|
Height twitches, int bright raster with fb lines | Resolder conns on digital panel | ||
| SANYO |
CBP2576A
|
Field top foldover & excess height | C703 100µ 50v | ||
| SANYO |
CBP2576 ED0
|
No sound | Carry out "start nvm" proc as described in manual | ||
| SANYO |
CBP2576 ED0
|
No e-w correction | Icp r756 (n20) o/c | ||
| SANYO |
CBP2576 ED0
|
Dead - whistle only - loptr 2sd1556 leaky | ,overheats when replaced with int narrow pic, replaced c750 47µ 50v & c705 2µ2 50v for hi esr & check for dry joints in lop section | ||
| SANYO |
CBP2576 ED0
|
Burning smell then dead | Burn up on pcb at line scan connector k-ff | ||
| SANYO |
CBP2576
|
Very bright raster sound ok | Check r534 22kΩ | ||
| SANYO |
CBP2576
|
Pin cush dist | Replace c750 2.2mfd | ||
| SANYO |
CBP2576
|
No sound | Replace icp853 and ic1680 | ||
| SANYO |
CBP2576
|
Just snow in tuning mode | Check for correct configeration number 02014 to enter service mode press memory on ct and within 5 secs press menu button on remote then enter the above number | ||
| SANYO |
CBP2576
|
Excess width & pin cush dist | Lakh0 & Satkha | ||
| SANYO |
CBP2572 ED1
|
White dot pattern | Dti2223-06 , on digital pcb | ||
| SANYO |
CBP2572 ED1
|
To reprog nvm memory chips | Press service button (thro' hole in set front) & vol+ together - be careful - all previous data will be lost! | ||
| SANYO |
CBP2572 ED1
|
Strange e/w fault | Check dpu2553/75 on digi board | ||
| SANYO |
CBP2572 ED1
|
Q903 s/c r301 ( 3r9 ) o/c | Check r3165 d/j and tea2260 | ||
| SANYO |
CBP2572 ED1
|
Int loss off air signals | Q173 d/d | ||
| SANYO |
CBP2572 ED1
|
Ew faulty | Dpu2553/75 deflection proc chip | ||
| SANYO |
CBP2572 ED1
|
Dead | R301 3r9 15w surge res o/c, q303 2sc4429 chopper tr s/c, r315 dry joints caused it-also ic301 tea2260 faulty | ||
| SANYO |
CBP2572 ED1
|
Dark & lacking contrast | Unable to get "ok" indication when adj a1 volts in service mode. ic501 vcu2136 on digital pcb faulty - pt no 409 212 0608 | ||
| SANYO |
CBP2572 ED1
|
Blank raster, no sound or osd | 2 x nvm chips on sigs panel sus; can be replaced or reprog |