Sanyo Repair Tips

Search: sanyo
Results: 852

Make	Model	Symptom	Problem
SANYO	CBP2180	Field bounce	L401 in field o/p supply intermittent
SANYO	CBP2168	No front controls so no tuning possible - r/c ok	D710. 711 6v2 zeners leaky on main pcb
SANYO	CBP2168	Int goes blank raster & no sound	Check 5v st/by supply present - sus st/by tfmr pri
SANYO	CBP2162 E4	No pic - sound ok - blank raster when a1 advanced	Low amplitude scastle pulse pin 27 - ic101 tda4505m faulty - first check 12v supply at pin 7, if low then sus ic362 l78m12-ra 12v reg
SANYO	CBP2162 E4	Blank raster with sound	Tda4505m ic101
SANYO	CBP2162	Int dead then perm dead	Ht present with snowy raster when a1 advanced - no r/c functs. no 5v to micro - st/by trfmr o/c pri
SANYO	CBP2162	Field non lin	Tda4505m - tried "e" suffix but would not work in spite of changing res
SANYO	CBP2152 E4	Dead - will briefly come out of st/by	Ht ok at lop - no line drive as 12v supply to pin 7 tda4505 was low; ic362 l78m12 reg chip faulty
SANYO	CBP2152	No pic for 1min then comes on all white for 30secs	Tda3566 us ( pal ntsc )
SANYO	CBP2152	Int stuck in stby also int random channel change	D674 6v2 zener other diodes in cct may cause similar faults
SANYO	CBP2152	Int failure to come out of st/by & random chan change	D746 6v2 zener between front panel & 'tac' switch
SANYO	CBP2148	St/by only	Momentary contacts on mains sw - should make b4 mains contacts
SANYO	CBP2147	St/by only	Fault in st/by cct - linked st/by conn on mains sw to chassis but no st/by facility now available
SANYO	CBP2146 E2-E21	Poor sync.	Ic1011 ( saa5230 )
SANYO	CBP2146 E2-E21	Picture fades shortly after switch on.	Sprinkle r479.
SANYO	CBP2146 E2-E21	Lack of width and shuts down when set is warm.	C310 ( .047uf 50v )
SANYO	CBP2146 E2-E21	Int red picture.	Drys a602 on crt base.
SANYO	CBP2146 E2-E21	Corrupted text.	Ic1031 ( saa5240a )
SANYO	CBP2146 E2-E21	Corrugated verticals.	Check eht lead connections.
SANYO	CBP2146 E2-E21	Bright raster with flyback lines.	R478 ( 10k ) o/c.