Sharp Repair Tips
Search: sharp
Results: 1784
Results: 1784
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SHARP |
C 1413 OU C453
|
Retrace line at the top of the screen. | Vertical return was not complete, r504 open | Replace the same | CALIXSERVICE |
| SHARP |
C-1412 B
|
Intermittent defect: Sometimes it turns on and other times it doesn't (giving the impression of the switch being on\off.) | Cause: electrolytic capacitor c 708 open (dry) 3.3mf\450v. | ReplaceIt | ADHEMAR CAETANO DA SILVA (TECMIL ELETRONICA) NOVA FRIBURGO, RJ |
| SHARP |
C-1417
|
TV with no image and no sound. Dark screen with all filament voltages and RGB | Shorted varicap had no attention from 5v | Replace the varicap. | EletroClaudio Aguas Belas |
| SHARP |
C-14R12
|
When plugging the TV into the socket, initially there was a knock in the draive | C=617, 561 | Replace and analyze possible components around you | ELETRONICA MEDEIROS |
| SHARP |
C-29ST58
|
When turning on, it kept beeping, without any trouble | D613,d616 short horizontal output burnt | Replaced diode 613 and d616 and horizontal output bu 2508af or bu2522ax | WILSON SAO ROQUE |
| SHARP |
C2038
|
TV doesn't turn on and power supply +b=97volts | Change c725=47mf/160v it returned to 105v and started working normally! | Alextecnico | |
| SHARP |
C-20T51
|
Does not turn on wobbles and cuts | C616 8n2 1600v | Replace | EletroClaudio Aguas Belas |
| SHARP |
C2053
|
No audio and output heating up | Saida those who ruim tda7056b | Replace the same | orlando lott |
| SHARP |
C2053
|
No audio | The resistor r302 1r open | Replace the same | orlando lott |
| SHARP |
C-29ST58B
|
White stripes at the top of the screen. | Change the capacitors c-502 and c-503 also check the 33 obms resistor r-505 must be changed | Ademar / Videira s.c | |
| SHARP |
C-2013 E C-2053
|
No video, only sound | Change ci tda 8361-4x | Ademar / Videira sc | |
| SHARP |
C2053
|
With high power supply 160volts | R731 1st altered | Replace r731 and the power supply returned to normal | |
| SHARP |
29L-FG 1BZ
|
Turn on and off | Error amplifier integrated circuit | Ic 714 tlp 431 | ELETRO CENTER |
| SHARP |
C2041
|
Scratches in the middle of the screen shrinking the image at the bottom and stretching at the top | Capacitor c504 100x35 | Swap c504 100x35 obs before the power supply was burned out. | celito santo angelo |
| SHARP |
C2057
142 |
Doesn't work | C621 shorted | Antonio ferreira costa | |
| SHARP |
C-2057 / C-1457
|
It automatically tunes but when changing channels the screen disappears with interference. | Tune in to a local channel, turn off the TV and enter service mode, press the 100 button on the remote control, if an error appears on the screen, wait a few minutes and press the 100 button on the remote control again until ok appears. | Ademar / Videira sc | |
| SHARP |
C-2057 / C-1457
|
Takes time to call | Changing electrolytic c-624 is on pin 1 of t 701 kinescope filament. | Ademar / Videira sc | |
| SHARP |
29ST58B
|
Just a scratch in the center of the closed vertical screen. | Replace q3701 (tda 8350) and the diode d-3718 (byv-95b | Ademar / Videira sc | |
| SHARP |
C-1432 E C-1632
|
TV with low volume | When this problem arises simply disconnect pin 8 of (ic-201) la-4265 | Ademar / Videira sc | |
| SHARP |
29L-FG1B (MODELO NOVO)
|
Blocked channels | With the control enter the password 2398 and enter the menu and deactivate it | Ademar / Videira sc |