Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY KV21T3
Volume goes to max, no remote or front control Replace micro
SONY KV21T1U
No txt, excess width/height, poor contrast Reset eeprom - press on the remote on screen display key no 5 vol up key tv set will come on with tt on screen press menu
SONY KV21LS30U
Bright raster with fb lines Adj a1 or focus resets pic - until next time - new loptx reqd 1-453-345-11
SONY KV21LS30
Dead - led flashes 11 times R648 (330k) o/c in power supply.
SONY KV2184-34
Won't start/ loud audible buzz.sometimes starts and switches off after a while.if stby pin(41) of mp desoldered,all ok Replace str50115.
SONY KV2184-34
Won't start. nothing heard upon switch-on. Diode d604 short circuited
SONY KV2184-34
Won't start, pin 41 (stby) of microcontroller is high. Replace q003. no leak or any other defect was detected with a vom.
SONY KV2184
Switches off on bright scenes R621 1r in psu slightly hi (1r4)
SONY KV2184
Dead - str50115 overheating Replaced chip (s/c pins 2 & 3) but still dead; d608 r2m diode s/c & ps801 800ma cct prot o/c
SONY KV2184
Chans won't lock when tuning & garbled osd La78lr05 5 legged 5v reg with µ reset built in faulty
SONY KV2170
Dead - ps603 o/c Replace the 1.0a ic link [icp-n25] ps603 (1-532-637-11) by the 2.5a ic link [icp-n75] (1-532-686-21). add the mtzj-t-77-5.6b diode d613 (8-719-923-38) between pins 1 (cathode) and 9 of ic603. add the mtzj-t-77-5.6b diode d614 (8-719-923-38) between pin 9 (cathode) of ic603 & ground.
SONY KV2153M
Dead with loptr s/c & sec prot diode Also replaced opto, res & caps in psu - after which inability to tune manually. use the auto tune facility
SONY KV211XMTU
Int goes bright green Q311 buffer display tr on video panel - 2sc2785 used as official replacement
SONY KV2096/92
Int swaps between tuner/av Fracture in earth's on sign board by screen can clips
SONY KV2096
Text shows blank screen only Rv3 txt preset contrast pot 100r o/c
SONY KV2075
Poor convergence L551
SONY KV2060/62 MK1&2
Blank raster and no sound although it appeared to lock sync blank stable pic ) 1/ d 102 in the mute cct ( mk1 versions only ) 2/ d 306 in pulse shaping cct ( both versions )
SONY KV2032ME
Pic only 3" wide on lh screen- increases as it warms up C514 = 33uf / 160v ; c801 = 22uf / 250v ; c557 = 2,2uf / 160v .
SONY KV2032ME
No horizontal synchronisation when cold. Replace capacitor c509 10uf near horizontal driver transformer.
SONY KV2032
Won't start, dead. Check/replace r627 2,2m resistor in the power supply.