Search: sony
Results: 20088
Make Model Symptom Problem Solution By
SONY AE2 KVE2932U
Excess width C819 470µ 16v - the -7.4v supply being poorly smoothed
SONY AE2 KVE2533E
Led blinks 13 times at sw on Frame drive chip was the cause aft replacing fop chip & still having same symptoms
SONY AE2 KVE2532U
Poor sync, mosaic & odd cols Dig comb filter
SONY AE-2
To disable prot line Remove pin 1 marked "prot" on µ pcb
SONY AE-2
Shuts down with bled flashing 13 times Field fault indication - but was r895 18k sm o/c which monitors line fb pulses
SONY AE2
Won't come out of st/by - int Field o/p chip tda8179
SONY AE2
Vertical ripple with staining effect D613 double diode in psu has leak in one leg
SONY AE2
Vertical ripple & 'staining' effect D613 - double diode in psu leaky
SONY AE2
Trips to st/by aft 2 secs - points to field fault Replace field chip & r854 0r47 as no -15v supplies were present
SONY AE2
Trips 13 times - indicates field fault Stb9379 field chip - can use tda8179s??
SONY AE2
Sound missing R627 27r fusible o/c brought back dist sound - ic261 tda2052 faulty causing uneven supply volts
SONY AE2
Sound cuts out when volume turned up D/j on x1101 crystal on nicam pcb
SONY AE2
Shuts down aft 30 seconds then switch back on after few mins then repeats sequence - no leds lit Ht measured 61v (st/by mode) - st/by 5v to micro low at 0.7v. cct prot ps681 int high res (on board a near front adj to board d)
SONY AE2
Set will only display one station if another is se Earom ( st24c16 ) data corrupted replace & set up
SONY AE2
Set comes on then collapses into lines in the cent Check h.t. for 119v if low at 70v q613 in audio protection cct pt no 8-729-216-22
SONY AE2
Random spikes and dist. high sound left speaker Add 3k3 res and 0.015mfd cap parallel toc201
SONY AE2
Pic int blanks out then shuts down & restarts Loss of field o/p - dry joints fop chip (next to lopt by back panel)
SONY AE2
Pic goes narrow with lines & high pitched whine loptx Ht low at 70v - q613 2sa1162g in audio prot cct faulty - critical pt no 8-729-216-22
SONY AE2
Periodical switching off and on ( 10 seconds ) Replace ic003 with ae20 type version v2.82
SONY AE2
Odd linearity faults looks like ringing Cxd2018q ic561 48 pin surface mount device ( good luck!! ) pt-no 8-752-347-92